zero look over

This is a motor mount and flex cable guard for the Traxxas DCB M41. Includes:1x DCB M41 Motor Mount1x Flex Cable Guard

This is the Rudder Mount and Rudder Pivot for the Traxxas DCB-M41 40" Twin Hull Catamaran. Features: Aluminum construction Anodized blue in col...

This is a 127.5mm rudder and assembly for the Traxxas DCB M41. Includes:1x 127.5mm Rudder1x Rudder Arm1x Hinge Pin2x 3x15mm Button Head Cap Screws ...

These are the Traxxas DCB M41 Boat Blue Aluminum Drive Strut Mounts (2).FitsDCB M41 boats

This is a radio tray with two retainers, a stuffing tube clamp, and two 4x16mm button head screws from Traxxas.

These are the 3.8 in. Canyon AT tires for use on the Traxxas Summit Truck RTR. Features: Aggressive, angular lugs Soft foam insets let the rubber ...

Traxxas Spring/Shock Red Long GTR 4.9 Rate Dbl Ylw Strp Features: Steel construction, red in color 4.9 damping rate with double yellow stripe mark...

This is the Traxxas Retainer Clip. This Retainer Clip is black colored and compatible with the Traxxas E-Revo.Features: Black in color Nylon const...

This is a pair of Rear Traxxas Pre-mounted Twin Spoke wheels with Victory tires. Victory rear tires incorporate the ultra low-profile 2.8" design w...

Traxxas Rear Twin Spoke Wheel 2.8" Chrome Jato (2) Features: Nylon construction Chrome plated Five split spoke wheel pattern Uses 12mm hex adapte...

Traxxas set of assembled left or right half shafts are direct replacement parts. Rubber sealed boots. Fully assembled Includes: Two assembled half ...

This is the Rear Bumperfor the Traxxas Nitro Jato Stadium Truck.FEATURES:Plastic constructionBlack in colorINCLUDES:One Rear Bumper.

This is the Wing Mount Hardware for the Traxxas Jato.FEATURES:Nylon flanged tapered nuts.Blue anodized aluminum countersunk cap head screws.INCLUDE...

This is the replacement Sway Bar Linkage Front for the optionalTraxxas Revo/Revo 3.3 sway bar kit - TRAC5598.FEATURES:Nylon and metal constructionB...

These are the GTR Shock Bodiesfor the Traxxas Nitro Jato Stadium Truck.FEATURES:Nylon constructionGray in colorMolded Composite INCLUDES:Two Molded...

This is a pair of Traxxas 1.4 Rate (Double Pink) GTR Shock Springs in Red for the Jato and XO-1. Traxxas offers a wide variety of spring rates for ...

TRA5432 Spring, shock (white) (GTR) (front) (1.3 rate gold) (1 pair)

This is the super shock spring 0.7 Yellow for the Traxxas Nitro Jato Stadium Truck.Features: Metal construction that’s white in color Yellow Weigh...

TRA5394 Forward only shaft, steel (Revo)

TRA5313R Decal sheets, Revo 3.3

Traxxas 90º pressure fitting is constructed of polished aluminum and threaded at one end. This is the pressure fitting that is used on the Tuned Pi...

These are the optional lightweight 112mm toe links with rod ends for the Traxxas Maxx models.Features: 30% lighter than stock steel toe links 4 ti...

This is the Replacement Pair of 14mm Snap Rings for the Gear Hub Assembly on the Traxxas T-Maxx 4WD Radio Control Monster Truck. These are extra sn...

TRA4977 Wheelie bar mount (1)

Features: Fits all Traxxas vehicles in the Revo and Maxx seriesIncludes: Two 3.8 Tires and foam insertsRequires: Installing on wheels with Tire Glu...

This is a pair of Traxxas Machined Aluminum Lower Chassis Braces in Blue with Hardware for the T-Maxx. These aluminum lower braces provide the ulti...

This is the replacement EZ start control box for the Traxxas EZ Start. This is the box that attaches to the 6-Cell battery and controls the start o...

TRA4513R Decal sheets, Nitro Sport

TRA4498 Owner's manual, Nitro Slash

Features:Painted whiteSteel construction Includes:Two springs Technical Specifications:Length: 3.11" (79mm)Inside diameter: .61" (15mm)Outside diam...

This is a pre-assembled tuned pipe for the Traxxas Rustler.Features: Plastic Construction Pre-Installed Pressure Tap and Wire Mount 90 Degree Rubb...

Traxxas fuel tank box, servo holder is constructed of gray nylon. Specs: Length: 88mm (3.47")Width: 101mm (3.98")Height: 28mm (1.10")

These cool, 5-spoke chrome wheels can be used to replace the dished wheels on older models. The TRX Pro-Star wheels feature a chrome-less gluing su...

Exhaust hanger, metal Replacement part for these models: TRX® Pro .15

This is the Shift Fork and Shaft included with the optionalTwo Speed Conversion Kit, TRAC4000 used on the Traxxas E-Maxx.FEATURES:Helps to control ...

This is a replacement Traxxas Decal Sheet, and is intended for use with the Traxxas Stampede.

Exhaust tube, (siliconee) (N. Stampede/ N. Vee)