This is the Traxxas left and right tail light housing, lens and decals set.Includes: Two tail light housing Two lens Left and right decals
This is a Traxxas Inner and Outer Bearing Retainer Set. Includes:2x Inner Bearing Retainers2x Outer Bearing Retainers
Ball bearings, black rubber sealed (4x10x4mm) (2) Pair of 4x10x4 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...
View full details
This is a replacement Traxxas TRX-4 Receiver Box Seal Kit, including a small tube of silicone grease.Â
This is a replacement Traxxas Maxx Differential Carrier Case. This set also includes one x-ring gasket, two o-rings, and one 10.5x19.5x0.5 washer. ...
View full details
These are the optional orange rate GTR shock springs for use on the Traxxas 1/16 E-Revo VXL 4WD RTR.Features: Steel construction that’s red in col...
View full details
TRA7666 Spring, shock (red) (GTR) (0.314 rate)(1 pair)
This is optional Heavy Duty Rod Ends from Traxxas. Features: Heavy duty plastic construction Black in color  Includes: (8) Rod Ends  Spec...
View full details
This is the 44-Tooth Transmission Output Gear from Traxxas. Includes: (1) Output Gear  Specs: 44 Tooth
Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...
View full details
This is a replacement Traxxas Front & Rear Steel Bulkhead Tie Bar Set, and is intended for use with the Traxxas 1/16 Grave Digger Monster Jam R...
View full details
This is the 2nd Gear for the 2-speed for the Nitro 4-Tec.FEATURES:Black nylon colorINCLUDES:One gear 37 Teeth
Manufacturer Description This is the Replacement Carrier Drive Dog for Traxxas E-Maxx Truck.This part is located in the gearbox in between the two ...
View full details
TRA4919 Servo mounts, throttle/ brake (1) (black)
This is a replacement Traxxas Receiver Cover, and is intended for use with the Traxxas Nitro Sport 1/10 Scale Nitro Truck.Â
Wheel hex clips (6) Set of six wheel hex clips Replacement part for these models: X-Maxx® Ultimate X-Maxx® XRT® Ultimate XRT®
Body mounts (posts), front & rear Front and rear body mounts Replacement part for these models: 1/18 LaTrax® Desert Prerunner 1/18 LaTrax® T...
View full details
Spur gear, 54-tooth (1.0 metric pitch) 54-tooth spur gear (1.0 metric pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas...
View full details
These are non-adjustable camber link for the Traxxas Rustler and Stampede.Features: Black Plastic ConstructionIncludes: Two Short and Two Long Link...
View full details
Carriers, stub axle (rear) (2) Standard rear stub axle carriers (2) Replacement part for these models: Ford Fiesta® ST Rally Ford® Fiesta® ST Ra...
View full details
Spur gear, 38-tooth (1.0 Module) 38-tooth spur gear (1.0 metric pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas model...
View full details
Attachment screws, shock (3x12mm shoulder screws) (6) Set of six 3x12 mm shoulder screws (shock attachment screws) with Phillips-drive heads. Rep...
View full details
Body clip (mounting clip), angled, 90-degrees (10) 90-degree mounting clips are perfect for battery latches, making battery access quick and easy...
View full details
This is the optional 36 tooth spur gear for the Traxxas Revo monster truck. This spur gear goes on the gear box to transfer power from the clutch b...
View full details
Camber link set (plastic / non-adjustable ) ( front & rear) (gray) Non-adjustable gray composite camber link set includes front and rear links...
View full details
Spur gear, 50-tooth (1.0 metric pitch) 50-tooth spur gear (1.0 metric pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas...
View full details
Spur gear, 58-tooth (0.8 metric pitch, compatible with 32-pitch) 58-tooth spur gear (32-pitch). Traxxas spur gears let you fine-tune the performan...
View full details
Battery hold-down plate (grey) / metal posts (2) / body clips (2) Gray battery hold-down with metal posts (2) and retaining clips (2). Replacemen...
View full details
Screws, 3x10 button-head machine (hex drive) (stainless steel)(6)
Spur gear, 50-tooth 50-tooth spur gear (48-pitch) with telemetry magnet holder. Traxxas spur gears let you fine-tune the performance of your Traxx...
View full details
This is a 28-tooth 48-pitch replacement pinion gear for the Traxxas 4-Tec.Features: Ideal replacement part for fine tuning your Traxxas 4-Tec 4WD ...
View full details
Input shaft (slipper shaft) / spring pin Replacement input shaft (slipper clutch shaft) for Magnum 272 transmissions. Does not fit Magnum 272R tra...
View full details
Spur gear, 86-tooth (48-pitch) (for models with Torque-Control slipper clutch) 86-tooth spur gear (48-pitch) for Torque Control slipper clutches. ...
View full details
This is a package of 6 threadlocked grubs (4mm) from Traxxas.Features: Threadlocking compound pre-applied Hardened steel construction Designed for...
View full details
TRA3752 Stub axle carriers (2) (requires 5x11x4mm bearings) ***** if not in stock order  RPM80385 or RPM80382 Stub axle carriers (2) (requires 5x...
View full details