These are the left and right differential housings for the Traxxas E-Maxx.Features: Constructed of plastic Replaces damaged or broken diff housing...
View full details
These are the Traxxas 4-Tec 2.0 Left and Right Stub Axle Carriers. These fit all versions of the 4-Tec 2.0, including the Ford GT and Mustang GT.Fi...
View full details
This is the Center Driveshaft for the Traxxas 1/10 scale Telluride 4x4.FEATURES:Plastic construction, blue in colorINCLUDES:Center Driveshaft with ...
View full details
This is the Rear Axle Mount Set for Suspension Links for the TRX-6 by Traxxas. Includes: (1) Rear Axle Mount Set
This is the Offset Rod Ends for the Traxxas TRX-4 and TRX-6. Features: Plastic in Construction  Includes: (4) Offset Rod Ends
This is the Replacement 43 Tooth 1st Speed Spur Gear for the Traxxas T-Maxx4WD Radio Control Monster Truck.This spur gear is installed in the trans...
View full details
This is a replacement Traxxas 4-Tec 2.0 Front and Rear Body Mount Set. Features:Factory Replacement Body Mount Set Includes:(1) Body Mount Set
This is the Traxxas Battery Door for the TQi Transmitter.Features: Grey colored Made of plastic Fits two and four channel TQi transmitters Protect...
View full details
These are the rod ends for the 1/16 scale Traxxas Revo and Slash series.Features: Black nylon constructionIncludes: Eight Nylon Rod Ends Eight Nyl...
View full details
Traxxas Seal Kit Rx Box Features: Properly seals receiver box to minimize dirt and moisture exposure Includes: Silicone grease One Gasket Two Fo...
View full details
This is a set of inner drive cups and screw pins for the Traxxas Ford GT 4Tec.
This is the motor cover plate for the Traxxas 1/16 scale Fiesta and Kyle Busch Race Truck.Features: Composite constructionIncludes: Motor Cover Mo...
View full details
This is the housing for the front and rear differential on the Traxxas Summit Truck RTR.Features: Nylon construction that is black in colorIncludes...
View full details
This is the Traxxas 1/10 Maxx Waterproof Receiver Box Seal Kit with O-ring, Seals, and Silicone Grease Stock Replacement OnMaxx 4S
This is a set of two replacement differential output yokes from Traxxas. These yokes attach to the differential, and the half shafts that drive the...
View full details
This is the Traxxas Camber rods, 2-degree/3-degree (6 each). This is Traxxas part number 7539Part Number: 7539 / TRA7539FitsLaTrax Rally
Caster blocks (left & right) (30-degree) Replacement left and right 30° caster blocks Replacement part for these models: Bandit® VXL Bandit®...
View full details
This is the Replacement Steel Constant Velosity Driveshaft Rebuild Kit for Unlimited Desert Racer. Includes: (2) Drive Pin (2) Cross Pin
This is the optional 11 Tooth Pinion Gear for the Traxxas X-Maxx.FEATURES:Hardened steel constructionReplaces stock 6491X 18T pinion gearCompatible...
View full details
This is a replacement Idle Mixture Screw for theTraxxas TRX 2.5 Carb (TRAG5252).FEATURES:Pre-installed gasketINCLUDES:One NeedleSPECS:Length: 13.8 ...
View full details
This is the Rear Bumper and Rear Body Mount for the Traxxas 4-Tec 2.0 AWD Chassis and Ford GT. Includes: (1) Rear Bumper (1) Rear Body Mount  ...
View full details
This is the fuel tank rebuild kit for the Traxxas Rustler.Features: Direct fit replacement partsIncludes: Tank cap Tank seal Tank cap spring Small...
View full details
TRA4980X Housings, diff (ring side/ non-ring side) (1 each)/ pinion collar (1)
This is the Data Link Telemetry Expander from Traxxas that connects #6550X Telemetry Expander 2.0 to the #3485 VXL-6s or #3496 VXL-8s ESC. Incl...
View full details
This is a replacement Traxxas 4-Tec 2.0 Camber and Toe Link Set. Features:Factory Replacement Part Includes:(6) Camber and Toe Links
TRA5281 Control box battery cover w/ belt clip (EZ-Start 2)
This is the replacement Differential Gasket/ X-Rings for the Traxxas E-Revo VXL Brushless. Includes: Differential Gasket X-Rings (2) 12.2x18x0.5 M...
View full details
This is the optional 13 Tooth Pinion Gear for the Traxxas X-Maxx.FEATURES:Hardened steel constructionReplaces stock 6491X 18T pinion gearCompatible...
View full details
This is a replacement Traxxas TRX-4 Rear Inner Portal Drive Housing Set. Features: Factory Replacement Part Nylon Construction Includes:(2) Rear...
View full details
This is the Rear Differential Housing for the Traxxas 4-Tec 2.0 chassis and Ford GT. Includes: (1) Rear Differential Housing Â
Traxxas optional 45T spur gear is constructed of black nylon. INCLUDES: One 45T spur gear. This is listed in the manual as the 1st gear.
This is the Replacement Differential Output Yokes for the Jato by Traxxas. Features: Nylon construction Black in color  Includes: (2) Diffe...
View full details
Differential output yokes, heavy duty (2)/ screw pin (2) Pair of heavy-duty differential output yokes with screw pins (2)
This is a replacement Traxxas TRX-4 Front/Rear Outer Portal Drive Housing Set. Features: Factory Replacement Part Nylon Construction Includes:(2)...
View full details
These are the GTR shock shafts for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles.Features: Aluminum construction that is silver in colorInc...
View full details