TRAXXAS CARS AND TRUCKS AND PARTS IN STOCK 2025

This is the Replacement Drive Hub Assembly for the Traxxas T-Maxx 4WD Radio Control Monster Truck.This drive hub assembly fits into the spur gear a...

REAR GEAR BOX

Traxxas 12-Tooth Machined Steel Front Differential Pinion Gear

This is an optional pack of four Traxxas Fender Extensions, intended for use with TRX-4 and TRX-6 Kits. Includes: (4) Fender extensions (24) 3x8...

Traxxas Skidplate, Axle, Front Or Rear (Stainless Steel) (2)

Traxxas Servo horn, steering, 6061-T6 aluminum (gray-anodized)/ 3x15mm BCS (with threadlock) (1)

Traxxas Distribution block, Pro Scale Advanced Lighting Control System

Traxxas Suspension pins, outer (hardened steel), 3x34mm (4), 3x37mm (4)

Traxxas Suspension Link Set, Complete (Front & Rear) (Includes Steering Link (1), Front Lower Links (2), Front Upper Links (2), Rear Links (4))...

Traxxas Suspension Link Set, Complete (Front & Rear) (Includes Steering Link (1), Front Lower Links (2), Front Upper Links (2), Rear Lower Link...

Traxxas Steering Link, 6061-T6 Aluminum (Green-Anodized)/ Servo Horn, Metal/ Spacers (2)/ 3X6mm Ccs (With Threadlock) (1)/ 2.5X7mm Ss (With Threadl...

TRA8849 Traxxas Output drive, transmission or differential (pin retainer

This is a replacement Traxxas Unlimited Desert Racer Motor Mount, with two included pins. Features:Factory Replacement Mount Includes: (1) Motor M...

This is the Battery Charger for the optional NiMH Batteryused in the Traxxas TQi Docking Base.FEATURES:Charges the optional Traxxas #3037 NiMH batt...

Turnbuckles, titanium 94mm (front tie rods) (2)/ billet aluminum wrench

Traxxas 7668X Wheel Nut Washer Aluminum Orange 3x12mm CS (4) LaTrax Teton / SST These are the Wheel Nut Washers for the LaTrax Teton Monster Truck ...

This is a replacement Traxxas Center Differential Gear Set, and is intended for use with the Traxxas Slash 4x4.

Bulkhead, Rear (Left & Right Halves) for Summit  Replacement Part For: Summit (Model# 56076-4)

This is the front bulkhead for use on the Traxxas Summit Truck RTR.Features: Nylon construction that is black in colorIncludes: One Front Bulkhead ...

FEATURES: Constructed of aluminum. INCLUDES: One Traxxas Exhaust Header Set for the Nitro 4-Tec and the Nitro Sport with: One Pipe Two 3mm x 25mm S...

Exhaust header Replacement part for these models: TRX® Pro .15

Gear set (for 2085 servo)

Traxxas 7541 LaTrax Rally Bushings 4x8x3mm (2) 6x10x3mm (8) 8x12x3.5mm (5)This is the Bushing Set for the Latrax Rally Car from Traxxas.FEATURESNyl...

These are the Traxxas Premounted Off-Road Monster Truck Tires on 5-Spoke Wheels for the LaTrax Teton Monster Truck.Features: Black colored Plastic...

Traxxas Motor coupler, collet style/ GS 4x3 (with threadlock) (1)/ Wrench, 10mm (2)

Traxxas Stuffing Tube (Assembled w/Liner) DCB M41Features:Holds propeller shaft/flex cable in placeMetal constructionIncludes:Stuffing Tube with Liner

This is the replacement primary clutch assembly for the Traxxas Revo. This part is located within the two-speed transmission.Features: Aluminum and...

FEATURES: Black plastic constructionINCLUDES: Two Gearbox halves (Front and Rear) One 40mm Guide Pin Five 3x12mm Roundhead Self-Tapping Screws Two ...

This is a set of two replacement short black ultra shocks from Traxxas. Includes part to build two shocks.

This is a set of Dual Profile Tires for the Traxxas Monster Jam series.FEATURES:Rubber construction, split vee designINCLUDES:Two Dual Profile Tire...

Traxxas Stub Axle, Front (2)/ Cross Pins (2)/ Drive Pins (4)

Traxxas Suspension arms, black, front/rear (left & right), heavy duty (2)

Wheel nuts, splined, 17mm, serrated (blue-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug no...

Traxxas Driveshaft assembly (left or right, front or rear) (1) (fully assembled, ready to install)/ screw pin (1)

This is a front winch bumper that fits that Traxxas TRX-4® 1969-1972 Blazer with 8855 winch. Features: D-rings Fairlead   Includes: (1) Fron...

Heavy-Duty X-Maxx® Suspension Arm Heavy-duty X-Maxx lower suspension arms utilize our latest proprietary composite material for extreme durabilit...

Driveshaft assembly (1), left or right (fully assembled, ready to install)/ 4x15mm screw pin (1) The fully-assembled driveshaft comes complete and...

This is a replacement pack of Traxxas 72mm GT-Maxx Steel Shock Shaft with a chrome finish with Rod Ends, intended for use with the Maxx 1/10 Brush...

Traxxas Tires, Mickey Thompson Baja Pro X 2.2x1.0" (2)

Traxxas Bumper, rear (with LED lights) (replacement for #10735 rear bumper)

Traxxas Rudder mount/ steering arm/ drive strut mount/ mounting hardware

Traxxas Roll Bar (Assembled) (Fits #9811 Series Bodies)

Traxxas Fr. Grille/Tailgate Panel/Led Lenses(Rear L&R)(#9811 Bod

Traxxas Chassis Rails 220mm (Steel) (Left & Right)

Traxxas Bumper Front (1)/ Rear (1)

Traxxas Steering Bellcranks/ Servo Saver