TRAXXAS CARS AND TRUCKS AND PARTS IN STOCK 2025

Battery expansion kit (allows for installation of taller multi-cell battery packs) (Rustler®, Bandit, Stampede®) The battery expansion kit allows ...

Traxxas Springs, shock (natural finish) (GTR short) (1.19 rate, green stripe) (1 pair)

Stub axles, rear, heavy duty (2)/pins (2) Pair of rear heavy-duty stub axles with pins (2) Replacement part for these models: Ford Fiesta® ST Ra...

The Traxxas Long Chassis Front Bulkhead is a replacement intended for the Traxxas Rustler 4x4. However, it can also be used with 4x4 VXL kits equip...

Body mount, front & rear (black)/ body posts, 52mm (2), 38mm (2), 25mm (2), 6.5mm (2)/ body post extensions (4)/ hardware Front and rear body ...

Ball bearings, black rubber sealed (8x16x5mm) (2) Pair of 8x16x5 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...

Gear, 23-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears) 23-tooth pinion gear (1.0 metric pitch) fits...

Ball bearings, blue rubber sealed (8x16x5mm) (2) Pair of 8x16x5 mm blue rubber seal ball bearings. Blue-seal ball bearings keep dust and grime out...

TRA9583 Traxxas Differential output cup, front or rear (hardened steel)

Traxxas Springs, shock, long (natural finish) (GTS) (0.29 rate, white stripe) (for use with TRX-4 Long Arm Lift Kit)

Lower chassis, low CG (black) Change up the color on your low-CG-equipped 2WD Slash with this accessory lower chassis. Does not fit standard chass...

Half-shafts (internal-splined (2)/external-splined (2))/ metal U-joints (4) Set of two half shafts includes internal shafts (2) and external shaft...

Traxxas Bumper mounts, front & rear/ bumper mount, rear (offset)

Traxxas Body Mount Rear/Body Mount Posts, Front (2) Features: Plastic construction Includes: One-piece Rear and two-piece Front Body Mounts Fit...

Turnbuckle, aluminum (blue-anodized), camber link, front, 39mm (1)(assembled w/rod ends)/hollow balls (2)(See part 3741A for complete camber link ...

Traxxas Servo saver/ servo saver spring/ servo horn, steering

Traxxas Roof, Body (Fits TRA9711 Body)

Traxxas Steering Blocks, Left & Right/ Caster Blocks (C-Hubs), Left & Right

Traxxas Rebuild Kit, Oil-Filled Shocks (O-Rings, Spacers, Bladders, Bottom Caps) (Renews 2 Shocks)

TRA9552 Traxxas Carriers, stub axle (left and right)

This is a replacement Traxxas Telemetry Expander Mount for the TRX-4. Features: Factory Replacement Part Nylon Construction Includes:(1) Telemet...

Gear, 18-T pinion (32-p), heavy duty (machined, hardened steel) (fits 3mm shaft)/ set screw The heavy-duty 18-tooth (32-pitch) pinion gear is mach...

Shock tower, rear Replacement rear shock tower Replacement part for these models: Hoss® 4X4 VXL Rustler® 4X4 Ultimate Rustler® 4X4 VXL Rustler® 4X4

Traxxas replacement slide carb linkage set includes all parts in linkage set. This linkage set will not work with the older T-Maxx with the Pro .15...

TRAXXAS Linkage, sway bar, front (2) (assembled with hollow balls)/ sway bar arm (left & right)

This is the Traxxas servo mount for steering chassis crossmember.

Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws

‹¯¨Top Gear Machined 22T SRT

These are 20 Groove Middle Pulleys by Traxxas.FEATURES:Black in colorHard Plastic Construction for the Pulleys and Flanges.Metal Construction for t...

This is a pair of Traxxas Aluminum Front/Rear Bulkhead Tie Bars in Blue with a 2.5x6mm Cap Screw for the 1/16 Scale Slash 4WD, E-Revo, E-Revo VXL, ...

This is a set of four Traxxas Molded Composite Push Rods in Red with eight Hollow Balls for the 1/16 Scale Slash 4WD and E-Revo.

Features:Hardened plastic constructionBlack in colorIncludes:One rear shock towerRequires:Installation on chassisTechnical Specifications:Length: 8...

This is the optional Battery Hold Down for the Traxxas Stampede 4x4 VXL.Features: Composite construction Allows installation of taller multi-cell ...

GEAR, 34-T PINION (1.0 METRIC PITCH), FITS 5MM SHAFT

This is the center half shaft set for the Traxxas E-Revo.Features: Plastic construction that’s black in colorIncludes: Center half shafts (three in...

This is the Input Shaft and Spacer for the Traxxas Nitro Jato Stadium Truck. FEATURES:Metal ConstructionBlack in color INCLUDES:One Input Shaft (Sl...

Traxxas Rear Stub Axle & Yokes Jato (2) Features: Metal and nylon construction Black in color Includes: Two Metal Rear Stub Axles w/Nylon Yo...

Traxxas left and right caster and steering blocks are constructed of nylon and black in color INCLUDES: One Left and Right 30 Caster Blocks One Lef...

This is the White Tension Shock Spring Set for the Revo GTR ShocksThese springs are installed on the shock bodies.FEATURES:Red in colorWhite band o...

This is the Differential Output Gear for the Traxxas Revo 3.3.FEATURES:Constructed of hardened steelINCLUDES:Differential Output Gear for the Traxx...

This is a Shift Fork/Shaft for the Traxxas Revo.FEATURES:Plastic shift fork constructionMetal shift fork shaftShift fork plastic is black in colorP...

Traxxas idler gear with bearing and support for the Revo. These parts install inside the transmission. Steel idler gear construction Plastic idler ...

Traxxas package of front and rear shock mounts for the Revo. INCLUDED: One front shock mount, Black Plastic, One rear shock mount, Four chassis wir...

Traxxas Primary Gears T-Maxx. This is the replacement primary gear set for the Traxxas T-Maxx 4WD Radio Control Monster Truck. This gear set is ins...

FEATURES: Fits first generation T-Maxx transmission without OptidriveSteel shaft with plastic gear22T and 17T gearsPre-assembled on shaft INCLUDES:...

FEATURES: Replaces damaged or worn 2-speed drive gearsGears are constructed of plastic and pre-installed on steel shaft INCLUDES: One 17 and 22 too...

This is the Transmission Skidplate for theTraxxas New T-Maxx 4WD Nitro Monster Truck RTRFEATURES:Attaches to and protects chassis and transmissionS...