Traxxas Drive Cup/Screw Pin M4/15 Features: Metal construction, red and silver in color Steel CV center driveshaft Includes: One sleeve One M4/1...
View full details
This is a 2WD Gear Hub and Snap Ring for the Traxxas Nitro 4-Tec. COMMENTS: There are two spur gear pins molded into the gear hub. pjm 2/12/03 ir/jxs
Traxxas Pro .15 to TRX 2.5 engine conversion has a tune Pipe, bellcrank, & Throttle Servo Horn made of plastic. Linkage wire made of steel. Spe...
View full details
Backplate (for recoil start engines) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
High-speed needle valve & seat assembly (w/ securing nut) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
Clutch bell, hardened steel (20-tooth) (32-pitch) (N. Hawk/Buggy/Street) ¶ÿ Accessory part for these models: TRX Pro .15
This is an optional Team Losi Racing Aluminum 5¶ôÇ÷ Low Roll Center Toe Plate, intended for use with the Team Losi Racing 22 1/10 buggy.
This is a Team Losi Racing Aluminum Hex Differential Wrench, intended for use with the Team Losi Racing 22 1/10 buggy.
Z3R-S Stock Spec 540 High-Torque Rotor, Green
Key Features Capable of maximum continuous discharge rates up to 25C and burst of 50C Ultra-fast charge capable of rates up to 5C (with approved ...
View full details
5000mAh 1S 3.7V Pro Race 40C LiPo w/Case, Deans
5000mAh 1-Cell/1S 3.7V G4 Pro Race 50Cw/Case,Deans
Key Features 4-pin balancer connector 16AWG wire 15C (31.5A) continuous
ACDC 1S LiPo Quad/4-Port 12V AC/DC Charger
