Transmission, complete (low range (crawl) gearing) (40.3:1 reduction ratio) (assembled with ball bearings) (includes Titan® 87T motor) Give your T...
View full details
Charger, iD® Balance, USB (2-cell 7.4 volt LiPo with iD® connector only) Use the 2-amp USB-A fast charger with your Power Cell 2s 2821 LiPo batter...
View full details
RACE-INSPIRED ENGINEERINGEXTREME 8S POWER AND SPEEDX-TRUCK™ SIZE AND STRENGTH The Traxxas XRT fuses race-inspired design and engineering with...
View full details
2021 Ford Bronco TRX4 Scale and Trail Crawler AN OFF-ROAD LEGEND RETURNS The legend is back. After 25 years, the Bronco has returned as Ford's top...
View full details
Ball bearing, black rubber sealed (6x16x5mm) (2) Pair of 6x16x5 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...
View full details
This is a Traxxas color-burst painted body with pre-applied decals for the 1/18 LaTrax Desert PreRunner 4WD racing truck.
Traxxas Power Tap Connector with Cable. Pakcage includes connector, power tap with cable and two 2.6x8mm button head screws. Use TRA6549 power tap...
View full details
This a steel servo horn from Traxxas intended for the Maxx vehicle. Features:Steel Construction Includes:(1) Steel Servo Horn
This is a replacement Traxxas Maxx Outer Stub Axle Assembly, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck. This part is for fron...
View full details
Gear set, metal (for 2085, 2085X servos) Replacement metal gear set for 2085X servo. Gears can also be used to upgrade 2085 servo. (Must swap all ...
View full details
Traxxas Paddle Tires let you tear up sand, snow - and even water! These paddles are pre-mounted on black wheels that will fit the Unlimited Desert ...
View full details
Videos LaTrax Alias Quad-Rotor Ready-To-Fly Helicopter Quad Rotor Flight Re-imagined,More Powerful, More Durable, More Fun! Alias is a cle...
View full details
Save 13%
Videos LaTrax Alias Quad-Rotor Ready-To-Fly Helicopter 2.4GHz radio system Quad-rotor thrust with auto-leveling 6-axis flight system Four ...
View full details
Ring gear, differential/ pinion gear, differential (machined, spiral cut) (front) Spiral-cut 37-tooth ring and 13-tooth pinion front differential ...
View full details
Ring gear, differential/ pinion gear, differential Differential ring and pinion gears Replacement part for these models: E-Revo® VXL Brushless
This is a pack of two replacement Traxxas E-Revo VXL 2.0 Center Half Shafts.
Carrier, differential (aluminum)/ (requires #7783X spider gear shaft) Aluminum differential carrier includes X-ring gaskets (2), ring gear gasket,...
View full details
The Traxxas E-Revo 2.0 Heavy-Duty Front Left Suspension Arm Set features a design which incorporates latest proprietary composite material. Traxxas...
View full details
This is the Traxxas X-Maxx Green Aluminum Motor Mount Washer and Screw Set. This set includes four washers and four screws.FitsX-Maxx 6SX-Maxx 8S
Bumper mounts, front & rear/ screw pins (4) Replacement front and rear bumper mounts for TRX-4®. Includes screw pins (4). Replacement part fo...
View full details
Screws, 3x30mm cap-head machine (hex drive) (6) 3x30 mm cap-head machine screws with hex drive heads. Set of six.
Features:Steel and aluminum constructionIncludes:Two each; Shafts and Aluminum SpacersFour Gear Pads
Ring gear, differential, 42-tooth (use with #7777, #7778 13-tooth differential pinion gears) 42-tooth differential ring gear. Use with 7777 13-toot...
View full details
This is a set of left and right rear stub axle carriers for the Traxxas X-Maxx Monster Truck. Features: Molded composite plastic construction Hold...
View full details
This is a set of Traxxas Steel upper and lower Tie Bars.Features: Steel construction Mounts upper and lower bulkhead halves in place Includes: On...
View full details
This is a set of Traxxas Box/Receiver/Wire Cover/Foam Pads.Features: Molded composite plastic receiver box with rubber plug Fastens to chassis to ...
View full details
This is a replacement LaTrax Steering Bellcrank Set. Package includes steering bellcranks, servo saver, spring, spring retainer, posts and draglink...
View full details
BULKHEAD, REAR Rear bulkhead for vehicles equipped with the low-CG 4X4 chassis. Does not fit standard chassis. For a complete chassis conversion, ...
View full details
This is a set of optional Traxxas Assembled Steel CV Driveshafts, and are intended for use with the Traxxas 1/16 E-Revo VXL.Traxxas Steel Constant ...
View full details
This is the Traxxas Y-Harness, Servo and LED Light Set.Features: Black and red colored Made of durable material Includes:One Traxxas Y-Harness, S...
View full details
Servo horn (with built-in spring and hardware) (for Summit locking differential) Shift servo horn with built-in spring tensioner Replacement part...
View full details
This is the Traxxas pair of assembled GTR blue-anodized aluminum shocks without springs for the Traxxas Revo, E-Revo, Summit, Slayer and Jato. GTR ...
View full details
Spring, shock (GTR) (6.4 rate purple) GTR shock springs use high-quality spring steel with a durable red powder-coated finish. GTR springs are off...
View full details
This is the throttle & brake linkage set for the REVO from Traxxas.Includes: Throttle & brake linkage rods Springs Thumb nut Various other...
View full details
