ALL TRAXXAS

This is the optional glow plug wrench from Traxxas.Features: Features aluminum construction and a dull silver color Will work on 7mm and 8mm glow ...

TRA3742 Shoulder screws, steering bellcranks

Screws, 3x10mm caphead machine (hex drive) (6)/ lockwashers (6)/ hex wrench Set of six 3x10 mm cap-head machine screws with hex drive heads and lo...

Front axles (2)

Traxxas Driveshaft assembly, rear, extreme heavy duty with 6mm axle (1)/ screw pin (1) (left or right) (fully assembled, ready to install) (for use...

Charger, iD® Balance, USB (2-cell 7.4 volt LiPo with iD® connector only) Use the 2-amp USB-A fast charger with your Power Cell 2s 2821 LiPo batter...

TRA9576 Traxxas Wheelie bar, black (assembled)

This is the Motor Mount Washers and Screws for the Traxxas X-Maxx. Features: Aluminum Construction Blue in Color Exact Fit   Includes: (4) W...

This is a replacement Traxxas Maxx Driveshaft Assembly, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.   Features: Factory Replac...

Push rod (steel), heavy duty (2) (assembled with rod ends) Replacement heavy-duty steel push rods for E-Revo® VXL. Rods come assembled with rod en...

Driveshafts, front, steel-spline constant-velocity (complete assembly) (2) Extreme heavy-duty front steel CV (constant velocity) driveshafts are e...

This is a set of two replacement stub axle carriers from Traxxas intended for the Maxx. Features: Traxxas Quality and Precision Factory Replacemen...

Battery, Series 4 Power Cell, 4200mAh (NiMH, 6-C flat, 7.2V) Traxxas 4000-series Power Cell NiMH battery packs provide 25% greater capacity tha...

Videos LaTrax Alias Quad-Rotor Ready-To-Fly Helicopter 2.4GHz radio system Quad-rotor thrust with auto-leveling 6-axis flight system Four ...

Transmitter, TQ 2.4GHz, 2-channel (transmitter only) Switch on the power and drive! That's all there is to it with the TQ™ 2.4GHz radio. There are...

This is a Traxxas Front/Rear Steel Center Assembled Constant-Velocity Driveshaft Set for the E-Revo VXL Brushless. These Constant Velocity Drivesha...

Gear, 16-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears) 16-tooth pinion gear (1.0 metric pitch) fi...

XL-5HV 3s Electronic Speed Control, waterproof (low-voltage detection, fwd/rev/brake) The high-voltage XL-5™ HV electronic speed control for TRX-4...

Nuts, 4mm flanged nylon locking, serrated (black) (10) Set of ten black flanged nylon locking nuts Replacement part for these models: 4-Tec® 2.0...

This is the complete differential assembly for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles. Not for use on 1/10 scale vehicles.Features: ...

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4) Set of two heavy-duty half shafts includes internal shaft...

This is a optional Traxxas Aluminum Steering Block Set, and is intended for use with the Traxxas Slash 4x4 truck. Precision-machined for total stee...

This is a pack of two replacement Traxxas Pre-Mounted Robby Gordon Rear Tire & Wheels, and is intended for use with the Traxxas Slash Robby Gor...

Servo horn (with built-in spring and hardware) (for Summit locking differential) Shift servo horn with built-in spring tensioner Replacement part...

This is the suspension multi-tool for Traxxas Revo. It is used to adjust the Shock Upper Cap, Shock Rod-end removal/install and to tighten/loosen t...

This is the black wing for the Traxxas Revo 3.3. This part attaches to the rear of the body.Features: Plastic construction that’s black in colorInc...

These are the replacement FWD/REV output gears for the Traxxas Nitro Revo Monster Truck.Features: Nylon construction that’s black and white in colo...

This is the Traxxas set of four Anodized 17mm Splined Wheel Hubs, (4). These Splined Wheel Hubs are red colored and compatible with the Traxxas Sla...

This is the upper & lower left front suspension arm set for the REVO from Traxxas.Features: Durable black nylon constructionIncludes: Upper and...

Suspension arms upper (1)/ suspension arm lower (1) (right front) Upper and lower front right suspension arms Replacement part for these models: ...

Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch) (for center differential) The 54-tooth spur gear (32-pitch) fits the 6814 center ...

This is a replacement Traxxas Body Mount Set. This set includes the front and rear mount.

Turnbuckles, toe link, 55mm (75mm center to center) (2)

Traxxas Suspension arms, black, front/rear (left & right), heavy duty (2)

NEW X-Maxx Unrelenting 4X4 power, mammoth size, and award-winning innovation make X-Maxx the ultimate monster truck. With 30+ volts of extreme ...