ALL TRAXXAS

Cush drive key/ pin/ elastomer damper Cush drive key includes pin and elastomer damper Replacement part for these models: E-Revo® VXL Brushless ...

Steering arm (upper & lower)/ servo saver/ servo saver spring/ steering arm shaft Upper and lower steering arms with integrated servo saver, s...

Clutch shoes (2)/ spring (N. Rustler/N.Sport/N.Stampede) Replacement part for these models: Nitro Rustler® Nitro Slash TRX® 2.5R TRX® 3.3 TRX® Pr...

Cover, gear/ rubber gear cover plug/ 3x6 RM (2) Replacement gear cover for Magnum 272 transmissions. Includes clutch nut adjustment cover plug and...

Spring pre-load spacers: 1mm (4)/ 2mm (2)/ 4mm (2)/ 8mm (2) Change the ride height on your vehicle with these spring pre-load spacers for Traxxas ...

Battery hold-down (grey) (1) / receiver hold-down (grey) (1) / metal posts (2)/ spacers (2)/ body clips (2)/ servo tape/ adhesive foam pad Gray ba...

Traxxas Heat Sink, Titan 87T Motor (6061-T6 Aluminum, Blue-Anodized)

Input gear, 22-tooth/ input shaft (transmission) (heavy duty) (fits Bandit®, Rustler®, Stampede®, Slash® 2WD) The heavy-duty input shaft features...

Wheel nuts, splined, 17mm, serrated (red-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug n...

Heavy-Duty X-Maxx® Suspension Arm Heavy-duty X-Maxx lower suspension arms utilize our latest proprietary composite material for extreme durabilit...

Mount, tie bar, front (1)/ rear (1)/ suspension pin retainer, front or rear (2) Front and rear tie bar mounts with front and rear suspension pin r...

Oil, differential (500K wt) (0.7 oz (20cc)) Thick 500k weight differential oil adds significant locking action to your differentials. Traxxas perf...

Balance Lead Adapter (2938X)The Traxxas Balance Lead Adapter connects batteries to the accessory LiPo Cell Voltage Checker (2968) to check battery ...

MODEL SPECS Name: Slayer® Pro 4X4 Type: Short Course Truck Speed: 45 mph, 50+ with optional 17-tooth clutch bell (5217), sold separatel...

Body reinforcement set (fits #7711 body) X-Maxx® body reinforcements provide added protection for your truck during extreme driving. These high-st...

These are the Traxxas 17mm Serrated Splined Wheel Nuts, replacement part for the X-Maxx and can also be used on the VXL Revo. Features: Aluminum c...

This is a replacement Traxxas 9 Tooth LaTrax Pinion Gear, for use with the LaTrax 1/18 Desert Runner and 1/18 Teton. Features:Factory Replacement G...

This is a replacement Traxxas 1/16 Steel Center Drive Shaft Set, and is intended for use with the Traxxas 1/16 scale family of 4WD vehicles. These ...

This is the clear LED lightbar in chrome for the Traxxas Stampede 4x4 VXL.Features: Four clear LED lights in chrome finish plastic housingsIncludes...

This is a pair of Traxxas optional red aluminum pushrods for the rocker arms on the REVO. These go between the rocker arms and the lower suspension...

Screw pins, 4x13mm (with threadlock) (4) Set of four 4x13 mm screw pins with hex-drive heads and threadlock Replacement part for these models: R...

This is the set of axle pins for the Traxxas T-Maxx 4WD RTR Monster Truck. These pins go through the stub axles on each wheel, the wheel hubs are t...

Traxxas Skid Plate Front Plastic Gray Features: Attaches to and protects chassis and supports the front bulkhead Skidplate is gray in color Inclu...

CS 3x10 flathead (hex drive) Set of four 3x10 mm flat-head machine screws with hex drive heads Replacement part for these models: 4-Tec® 2.0 AWD...

This is the optional glow plug wrench from Traxxas.Features: Features aluminum construction and a dull silver color Will work on 7mm and 8mm glow ...

TRA3742 Shoulder screws, steering bellcranks

Screws, 3x10mm caphead machine (hex drive) (6)/ lockwashers (6)/ hex wrench Set of six 3x10 mm cap-head machine screws with hex drive heads and lo...

Front axles (2)

Traxxas Driveshaft assembly, rear, extreme heavy duty with 6mm axle (1)/ screw pin (1) (left or right) (fully assembled, ready to install) (for use...

Charger, iD® Balance, USB (2-cell 7.4 volt LiPo with iD® connector only) Use the 2-amp USB-A fast charger with your Power Cell 2s 2821 LiPo batter...

TRA9576 Traxxas Wheelie bar, black (assembled)

This is the Motor Mount Washers and Screws for the Traxxas X-Maxx. Features: Aluminum Construction Blue in Color Exact Fit   Includes: (4) W...

This is a replacement Traxxas Maxx Driveshaft Assembly, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.   Features: Factory Replac...

Push rod (steel), heavy duty (2) (assembled with rod ends) Replacement heavy-duty steel push rods for E-Revo® VXL. Rods come assembled with rod en...

Driveshafts, front, steel-spline constant-velocity (complete assembly) (2) Extreme heavy-duty front steel CV (constant velocity) driveshafts are e...

This is a set of two replacement stub axle carriers from Traxxas intended for the Maxx. Features: Traxxas Quality and Precision Factory Replacemen...

Battery, Series 4 Power Cell, 4200mAh (NiMH, 6-C flat, 7.2V) Traxxas 4000-series Power Cell NiMH battery packs provide 25% greater capacity tha...

Videos LaTrax Alias Quad-Rotor Ready-To-Fly Helicopter 2.4GHz radio system Quad-rotor thrust with auto-leveling 6-axis flight system Four ...

Transmitter, TQ 2.4GHz, 2-channel (transmitter only) Switch on the power and drive! That's all there is to it with the TQ™ 2.4GHz radio. There are...

This is a Traxxas Front/Rear Steel Center Assembled Constant-Velocity Driveshaft Set for the E-Revo VXL Brushless. These Constant Velocity Drivesha...

Gear, 16-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears) 16-tooth pinion gear (1.0 metric pitch) fi...

XL-5HV 3s Electronic Speed Control, waterproof (low-voltage detection, fwd/rev/brake) The high-voltage XL-5™ HV electronic speed control for TRX-4...

Nuts, 4mm flanged nylon locking, serrated (black) (10) Set of ten black flanged nylon locking nuts Replacement part for these models: 4-Tec® 2.0...

This is the complete differential assembly for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles. Not for use on 1/10 scale vehicles.Features: ...

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4) Set of two heavy-duty half shafts includes internal shaft...

This is a optional Traxxas Aluminum Steering Block Set, and is intended for use with the Traxxas Slash 4x4 truck. Precision-machined for total stee...

This is a pack of two replacement Traxxas Pre-Mounted Robby Gordon Rear Tire & Wheels, and is intended for use with the Traxxas Slash Robby Gor...

Servo horn (with built-in spring and hardware) (for Summit locking differential) Shift servo horn with built-in spring tensioner Replacement part...