Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...
View full details
Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws
FEATURES: Black nylon construction INCLUDES: One left chassis stiffener One right chassis stiffener REQUIRES: Installation onto vehicle. SPECS: Lef...
View full details
Traxxas Pro .15 to TRX 2.5 engine conversion has a tune Pipe, bellcrank, & Throttle Servo Horn made of plastic. Linkage wire made of steel. Spe...
View full details
Traxxas 4372 Wheel Chrome Nitro 4-Tec (2) These are the Replacement Chrome Wheels for the Electric Traxxas 4-Tec.Features: Nylon Construction Chro...
View full details
FEATURES: Nylon reinforced plastic construction 0° of casterINCLUDES: -One Front Lower Suspenson MountCOMMENTS: This part mounts to the chassis and...
View full details
This is a set of replacement Traxxas Rear Stub Axle Carriers, and are intended for use with the Traxxas Nitro Rustler, and Street Sport vehicles.
Starter shaft Replacement part for these models: TRX® Pro .15 Accessory part for these models: TRX® Pro .15 Marine
Backplate (for recoil start engines) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
High-speed needle valve & seat assembly (w/ securing nut) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
Low-speed spray bar Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
Needle screw, idle mixture Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
Stud & nut, carburetor attachment Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine
Gaskets, head (aluminum) (2) Replacement part for these models: TRX® Pro .15
Brake support bracket/ brake band/ 3x25mm roundhead machine screw (1)/ 3x16mm cap hex screw Replacement part for these models: TRX® Pro .15 Marine
4026 - Wrist pin/ G-spring retainer (wrist pin keeper) (1)
These are the Replacement 20 Tooth Idler Gears for the Traxxas E-Maxx Truck.These gears are located in the gearbox.FEATURES:Plastic constructionINC...
View full details
Countersunk Screws,3X24mm (6) (back wall)
Clutch bell, hardened steel (20-tooth) (32-pitch) (N. Hawk/Buggy/Street) ¶ÿ Accessory part for these models: TRX Pro .15
Save 46%
Screw set for Sledgehammer (assorted machine and self-tapping screws, no nuts)
Differential bevel gear set (3-small & 2-large side bevel gears)
Diff gear side plates/ ball joint plate
