Control box (complete) (EZ-Start® 2) Replacement starter control box for the EZ-Start® 2 starter. Replacement part for these models: Jato® Nitro...
View full details
This is the Traxxas Battery Hold-Down with Tall Retainers for the 1/10 scale Rally VXL and Slash LCG.Features: Black colored Made of plastic For t...
View full details
Suspension arm set, front (includes upper right & left and lower right & left arms) Front suspension arm set includes upper right & le...
View full details
These are the rubber sealed ball bearings for use on the Traxxas 1/16 E-Revo and Slash VXL 4WD vehicles.Features: Blue rubber sealed May also be u...
View full details
Spur gear, 38-tooth (1.0 Module) 38-tooth spur gear (1.0 metric pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas model...
View full details
Idler gear, steel (30-tooth) Replacement 30-tooth steel idler gear for the Magnum 272 transmission. Does not fit Magnum 272R transmission. Repla...
View full details
This is the Traxxas 30cc tube of Marine Grease.Features: 1 oz (30cc) tube Roll-up toothpaste-style tube Includes:One 1 oz tube of Traxxas marine ...
View full details
Box, receiver (sealed)/ foam pad/ silicone grease/ 3x8mm BCS (2)/ 2.5x8mm CS (2)/ 3x6mm BCS (2) Waterproof receiver box includes foam pad, silic...
View full details
Air filter inserts, foam (3) (pre-oiled) (TRX® 2.5) Pack of three replacement pre-oiled air filter inserts for TRX® 2.5, 2.5R, and 3.3 engines. R...
View full details
Rebuild kit, Velineon® 3500 (includes plastic endbell,  5x11x4mm ball bearings (2), 2.5x5mm BCS (with threadlock) (4), rear bushing) Rebuild kit f...
View full details
Wheel hex clips (6) Set of six wheel hex clips Replacement part for these models: X-Maxx® Ultimate X-Maxx® XRT® Ultimate XRT®
This is the chassis for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles.Features: Nylon construction that is grey in colorIncludes: One Chass...
View full details
Body mounts, front & rear/ body mount posts, front & rear/ 2.5x18mm screw pins (4)/ 4x10mm BCS (1) Front and rear body mounts and body pos...
View full details
Screws, 3x15mm countersunk machine (6) (hex drive)
Screws, 3x12mm countersunk machine (6) (hex drive) 3x12 mm countersunk machine screws with hex drive heads. Set of six. Replacement part for thes...
View full details
Driveshafts, rear, steel-spline constant-velocity (complete assembly) (2)
Spur gear, 54-tooth, steel (1.0 metric pitch) 54-tooth spur gear (1.0 metric pitch) has steel teeth for superior power handling and durability. ...
View full details
Body mounts (posts), front & rear Front and rear body mounts Replacement part for these models: 1/18 LaTrax® Desert Prerunner 1/18 LaTrax® T...
View full details
Features:Steel constructionIncludes:One Differential Ring GearOne Differential Pinion GearRequires:Installation in differential assemblyTechnical S...
View full details
Screw pin set (Rustler®/ Bandit/ Stampede®) Suspension screw pin set Replacement part for these models: Bandit® BIGFOOT® No. 1 Officially Licens...
View full details
Washers, 3x6mm metal (12) Pack of twelve 3x6 mm metal washers Replacement part for these models: Drag Slash 1967 Chevrolet® C10 Truck Drag Slash...
View full details
Gear, 20-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears) 20-tooth pinion gear (1.0 metric pitch) fits...
View full details
Traxxas BEC, complete (includes receiver box cover and seals)
Ball bearings, black rubber sealed (6x13x5mm) (2) Pair of 6x13x5 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...
View full details
These are the Traxxas Ball Bearings for the LaTrax Rally Car.Features: Silver/grey colored Made of Steel for a long life time Replaces all bushing...
View full details
Hollow balls, steel (machined) (22) Increase precision and extend wear with this set of twenty fully machined steel hollow balls for 1/16 models. ...
View full details
This is a Traxxas M0.8P, 52T spur gear.Features: M0.8 pitch 52 tooth Black plastic construction Compatible with 32P pinion gears Includes: One M0...
View full details
TRA5459 Revo T-Maxx Rubber Driveshaft Boots(2) Boots, driveshaft (rubber) (2) Replacement part for these models: E-Revo Brushless E-Revo Revo T-Maxx
Screws, 3x8mm flat-head machine (hex drive) (6) Set of six 3x8 mm flat-head machine screws with hex-drive heads Replacement part for these models...
View full details
Servo, digital high-speed, metal gear (ball bearing), waterproof The digital 2075R High-Speed Metal Gear Servo features a waterproof case for worr...
View full details
Pipe coupler, molded (for use with pipes 5152 (T-Maxx®) & 4452R) (TRX® 2.5, 2.5R, 3.3) Blue pipe coupler for use with pipes 5152 and 4452R exh...
View full details
Shock caps, aluminum (red-anodized) (4) (fits all Ultra Shocks) Aluminum shock caps are great way to boost the durability and style of any Traxxas...
View full details
Traxxas Oil, shock (80 wt, 1,000 cSt, 60cc) (silicone)
TRA5042 Traxxas Oil, differential (1M weight) (standard)
Ball bearings, blue rubber sealed (6x13x5mm) (2) Pair of 6x13x5 mm blue rubber seal ball bearings. Blue-seal ball bearings keep dust and grime out...
View full details
aving spare hardware is a smart choice, this is a replacement LaTrax Rally Screw Set. This set includes the necessary replacement hardware for the ...
View full detailsWe invite you to join our mailing list to receive specials and promotions.
EMAIL:Â sales@bigboyswithcooltoys.ca
STORE LOCATION: OR-
TEXT 647-321-1965
Need help ONLINE ?
text online support MESSAGES WILL BE ANSWERED
from 10am to 3pm - EST- 7 DAYS A WEEK
** Response times From senior staff 2 TO 3HRS