Gearbox halves (L&R) (grey) w/ idler gear shaft Gray gearbox halves (L&R) for Magnum 272 transmission. Includes idler gear shaft. Will not...
View full details
Hollow balls, steel (machined) (22) Increase precision and extend wear with this set of twenty fully machined steel hollow balls for 1/16 models. ...
View full details
Bumper, front Front bumper Replacement part for these models: X-Maxx® Ultimate X-Maxx®
Heat sink, Velineon® 380 brushless motor, aluminum (blue-anodized) Add the blue-anodized aluminum heat sink to your Velineon 380 brushless motor t...
View full details
Suspension arms (front) (2) Black front suspension arms (L&R) Replacement part for these models: BIGFOOT® No. 1 Officially Licensed Replica ...
View full details
Traxxas Maxx Front/Rear Skidplate Set. Package includes replacement front and rear skidplates.  Replacement part for these models: Maxx®
Suspension arm set, front (includes upper right & left and lower right & left arms) Front suspension arm set includes upper right & le...
View full details
TRA9549 Traxxas Toe links, front (2) (assembled with hollow balls)
This is a set of eight Traxxas Heavy Duty Toe Link Rod Ends with pre-installed hollow balls ready for installation on the E-Revo VXL Brushless.
This is the Traxxas chassis crossmember set. Includes: One intermediate One rear Left and right shock mounts
Chassis top brace Replacement X-Maxx® chassis top brace Replacement part for these models: X-Maxx® Ultimate X-Maxx®
TRA5102A Ball bearings, black rubber sealed (15x21x4mm) (2)
Suspension pin set, front or rear corner (hardened steel), 4x85mm (1), 4x47mm (3), 4x33mm (2) (qty 4, #7740 required for complete set) Hardened ste...
View full details
Traxxas offers a wide variety of spring rates for the shocks to precisely compensate for lighter or heavier truck configurations. The springs use h...
View full details
Ball bearings (5x10x4mm) (2) (metal shielded, for clutch bell) Pair of 5x10x4 mm ball bearings Replacement part for these models: Jato® Revo® Sl...
View full details
TRA9586 Traxxas Differential output cup, center (hardened steel)/ 2.5x12
TRA9554 Traxxas Stub axle, rear (for use only with #9557 rear driveshaft)
Ball bearings, blue rubber sealed (12x18x4mm) (2) Pair of 12x18x4 mm blue rubber seal ball bearings. Blue-seal ball bearings keep dust and grime o...
View full details
Skidplates, front & rear (black) Black front and rear skid plates Replacement part for these models: Ford® F-150 Raptor Ford® F-150® Raptor ...
View full details
Ball bearings, black rubber sealed (12x18x4mm) (2) Pair of 12x18x4 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal...
View full details
Steering link, steel/ servo saver spring, heavy duty (use with #2085X metal gear servo) The stiffer heavy-duty servo saver spring and steel stee...
View full details
This is a replacement Traxxas Wheelie Bar Mount/Rear Skidplate Set, and is intended for use with the Traxxas Stampede 4X4. Features: Factory Repla...
View full details
TRA5334 Axle carriers, left & right (1 each)
TRA9218 Traxxas Door handles / trail sights / trail sight retainers (2)