Air filter body (high-volume)/ filter support/ cap/ foam filter, pre-filter/ Revo® air filter base (angled)/wire mount/hardware (1 each) (TRX® Eng...
View full details
This is a replacement part for the Traxxas Unlimited Desert Racer. Features:Factory Replacement Part Includes:(2) Trailing Arms
This is the White Wing for the Traxxas Revo 3.3.This part attaches to the rear of the body.FEATURES:Plastic construction, white in colorINCLUDES:On...
View full details
Traxxas TRX-4 Chevrolet Blazer Front Bumper. Package includes replacement chrome bumper, bumper mount and lenses.
This is the Traxxas Auto-Detectable Voltage Sensor.Includes:One Traxxas Auto-Detectable Voltage Sensor.
This is the replacement primary clutch assembly for the Traxxas Revo. This part is located within the two-speed transmission.Features: Aluminum and...
View full details
TRA9490X Traxxas Plate, motor, blue (4mm thick) (aluminum)
TRA9490R Traxxas Plate, motor, red (4mm thick) (aluminum)
TRA9096 Traxxas Bumper, front (with LED lights) (replacement for #9035)
TRA8840 Traxxas Cable, T-lock, 4XL (417mm)
This is a pair of Traxxas Steel Constant Velocity Driveshaft Inner Drive Cups with Screw Pins for the Ford GT, Mustang GT and the 4-Tec 2.0 chassis.
This is the 24-Tooth High Range Metal Output Gear for the Traxxas TRX-4. and TRX-6 Features: Metal in Construction Includes: (1) Output Ge...
View full details
FEATURES: Black plastic constructionINCLUDES: Two Gearbox halves (Front and Rear) One 40mm Guide Pin Five 3x12mm Roundhead Self-Tapping Screws Two ...
View full details
This is a set of two replacement short black ultra shocks from Traxxas. Includes part to build two shocks.
These are the optional aluminum push rods for the Traxxas Slayer Pro 4WD Short Course Nitro RTR.Features: Aluminum construction with Nylon rod ends...
View full details
This is a pair of Traxxas optional red aluminum pushrods for the rocker arms on the REVO. These go between the rocker arms and the lower suspension...
View full details
Convert your Traxxas Revo to forward only with this Forward Only Conversion Kit. All parts required to convert the Revo to forward only INCLUDES: O...
View full details
This is the aluminum rocker arm post set for the Traxxas Revo. It provides a pivot point for the suspension/shock rocker arms.Features: Aluminum c...
View full details
TRA9355 Traxxas Driveshaft, center, steel (266mm)/ pin/ support, center
This is a replacement Traxxas 96mm Unlimited Desert Racer Steel Constant-Velocity Driveshaft Bone. Features:Factory Replacement Part Includes:(1) D...
View full details
Steering bellcranks/ servo saver/ servo saver spring/ servo spring retainer/servo horn, steering Steering bellcrank set features bellcrank, servo ...
View full details
This is an optional Traxxas "Long" Temperature & Voltage Sensor. Temperature data is critical to monitoring performance, gauging the effects of...
View full details
TRA9215 Traxxas Body cage (fits #9211 body)
Cable, T-lock (front) Replacement front differential T-Lock cable for TRX-4® and TRX-6® models. Replacement part for these models: TRX-4® 1972 C...
View full details
Driveshaft assembly (1), left or right (fully assembled, ready to install)/ 4x15mm screw pin (1) The fully-assembled driveshaft comes complete and...
View full details
Box, receiver (sealed)/ foam pad/2.5x8mm CS (4)/ 3x10mm CS (2) Sealed receiver box for Traxxas micro receivers. Includes foam pad, silicone seal...
View full details
TRA9558 Traxxas Driveshaft, front, steel constant-velocity (shaft only,
Traxxas 8633R Suspension Arms Red Rear (Right) Adjustable Wheelbase E-RevoIncludes:Suspension arms, red, rear (right), heavy duty, adjustable whee...
View full details
Driveshaft assembly (1), left or right (fully assembled, ready to install)/ screw pin (1) Fortified for hard launches and superior durability, Ex...
View full details
Wheel nuts, splined, 17mm, serrated (blue-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug no...
View full details
This is a Traxxas Steering Bellcranks/bellcrank Support/Servo Saver.Features: Molded composite plastic construction and Steel servo saver springInc...
View full details
This is the Replacement Backplate for the Traxxas 2.5 engine.This backplate is used on the 2.5 equipped with EZ starter.FEATURES:Aluminum construct...
View full details
This is a set of Traxxas Maxx’s extreme-duty cold-weather suspension arms, available in 6 colors to allow you to customize your truck to your style...
View full details
Traxxas Driveshaft, center, aluminum (fits Maxx V2 with extended chassis (352mm wheelbase))
Bulkhead, front (upper and lower) Front upper and lower bulkhead halves Replacement part for these models: Maxx® Slash® Maxx®
This is the ring gear and parts for the Traxxas T-Maxx 4WD Radio Control Monster Truck. These ring and pinion gears are installed in the front diff...
View full details
This is a replacement Traxxas 122.5mm Heavy Duty Steel Constant-Velocity Driveshaft; shaft only.
Box, receiver (sealed)/ foam pad/ 2.5x8mm CS (4)/ 3x10mm CS (2)Replacement part for these models:Rustler 4X4 VXLRustler 4X4
TRA9533X Traxxas Suspension arm, rear (right), blue
Steering arm (upper & lower)/ steering link/ servo horn/ servo saver/ servo saver spring/ servo horn mount/ ball stud (2)/ shock mounts, front...
View full details
Driveshaft assembly, front, extreme heavy duty (1) (left or right) (fully assembled, ready to install)/ screw pin (1) Designed for extreme perform...
View full details
Box, receiver (sealed)/ foam pad/ silicone grease/ 3x8mm BCS (2)/ 2.5x8mm CS (2)/ 3x6mm BCS (2) Waterproof receiver box includes foam pad, silic...
View full details
TRA9534 Traxxas Suspension arm, rear (left), black
TRA8841 Traxxas Cable, T-lock (rear) (6X6)
This is the Traxxas slipper clutch rebuild kit.Includes: Two steel disc Two friction insert 4.0mm NL Two spring washers
