Ball bearings, blue rubber shield (5x10x4mm) (2) Pair of 5x10x4 mm blue rubber seal ball bearings. Blue-seal ball bearings keep dust and grime out...
View full details
TRA4965 Brake pads (2)/ brake piston/ 3x15mm cap hex screws (2)
Traxxas throttle and brake servo mounts for the T-Maxx 3.3 is constructed of gray plastic. Includes: Two servo mounts Specs:Length:Â 1-3/8" (36mm)Wi...
View full details
This is the Replacement Idler Gear and Shaft for the Nitro Stampede/Rustler.This gear is located in the transmission. Features White nylon construc...
View full details
These are the 3mm x 10mm shoulder screws for the Traxxas Nitro Jato Stadium Truck.Features: Metal construction that’s black in colorIncludes: Six 3...
View full details
Traxxas Shoulder screws, 3x10mm (6) (with threadlock)
TRA9361 Traxxas Springs, shock (red) (1.029 rate) (2) Fits: Traxxas Factory Five 33 hot rod coup Traxxas Factory Five 35 hot rod truck
Ball bearings, black rubber sealed (5x10x4mm) (2) Pair of 5x10x4 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...
View full details
This is the optional 12 Tooth Pinion Gear for the Traxxas X-Maxx.FEATURES:Hardened steel constructionReplaces stock 6491X 18T pinion gearCompatible...
View full details
This is the Traxxas Nerf bars, chassis (black). This is Traxxas part number 5923Part Number: 5923 / TRA5923FitsSlayerSlayer Pro
TRA4428 EZ-Start mount/ clamp/ 2.6x10mm RST (4)
This is the small rod end set for the Traxxas Revo.Features: Plastic construction that’s black in color Metal Pivot Balls Includes: Six Rod Ends ...
View full details
This is a pair of replacement drive yokes for the Traxxas Revo. These yokes attach to the half shaft assemblies.Features: Black plastic constructio...
View full details
This is the Brake Yoke w/Pins for the Traxxas Revo.It is use on the Center/Front Driveshaft Assembly.FEATURES:Plastic Brake YokeSteel Brake Pins(ea...
View full details
These are the left and right differential housings for the Traxxas E-Maxx.Features: Constructed of plastic Replaces damaged or broken diff housing...
View full details
These are the Traxxas 4-Tec 2.0 Left and Right Stub Axle Carriers. These fit all versions of the 4-Tec 2.0, including the Ford GT and Mustang GT.Fi...
View full details
This is the Center Driveshaft for the Traxxas 1/10 scale Telluride 4x4.FEATURES:Plastic construction, blue in colorINCLUDES:Center Driveshaft with ...
View full details
This is the Rear Axle Mount Set for Suspension Links for the TRX-6 by Traxxas. Includes: (1) Rear Axle Mount Set
This is the Offset Rod Ends for the Traxxas TRX-4 and TRX-6. Features: Plastic in Construction  Includes: (4) Offset Rod Ends
This is the Replacement 43 Tooth 1st Speed Spur Gear for the Traxxas T-Maxx4WD Radio Control Monster Truck.This spur gear is installed in the trans...
View full details
This is a replacement Traxxas 4-Tec 2.0 Front and Rear Body Mount Set. Features:Factory Replacement Body Mount Set Includes:(1) Body Mount Set
This is the Traxxas Battery Door for the TQi Transmitter.Features: Grey colored Made of plastic Fits two and four channel TQi transmitters Protect...
View full details
These are the rod ends for the 1/16 scale Traxxas Revo and Slash series.Features: Black nylon constructionIncludes: Eight Nylon Rod Ends Eight Nyl...
View full details
Traxxas Seal Kit Rx Box Features: Properly seals receiver box to minimize dirt and moisture exposure Includes: Silicone grease One Gasket Two Fo...
View full details