This is the Replacement Differential Output Yokes for the Jato by Traxxas. Features: Nylon construction Black in color Includes: (2) Diffe...
View full details
Differential output yokes, heavy duty (2)/ screw pin (2) Pair of heavy-duty differential output yokes with screw pins (2)
This is a replacement Traxxas TRX-4 Front/Rear Outer Portal Drive Housing Set. Features: Factory Replacement Part Nylon Construction Includes:(2)...
View full details
These are the GTR shock shafts for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles.Features: Aluminum construction that is silver in colorInc...
View full details
This is the Traxxas left and right tail light housing, lens and decals set.Includes: Two tail light housing Two lens Left and right decals
This is a Traxxas Inner and Outer Bearing Retainer Set. Includes:2x Inner Bearing Retainers2x Outer Bearing Retainers
Ball bearings, black rubber sealed (4x10x4mm) (2) Pair of 4x10x4 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...
View full details
This is a replacement Traxxas TRX-4 Receiver Box Seal Kit, including a small tube of silicone grease.
This is a replacement Traxxas Maxx Differential Carrier Case. This set also includes one x-ring gasket, two o-rings, and one 10.5x19.5x0.5 washer. ...
View full details
These are the optional orange rate GTR shock springs for use on the Traxxas 1/16 E-Revo VXL 4WD RTR.Features: Steel construction that’s red in col...
View full details
TRA7666 Spring, shock (red) (GTR) (0.314 rate)(1 pair)
This is optional Heavy Duty Rod Ends from Traxxas. Features: Heavy duty plastic construction Black in color Includes: (8) Rod Ends Spec...
View full details
This is the 44-Tooth Transmission Output Gear from Traxxas. Includes: (1) Output Gear Specs: 44 Tooth
Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...
View full details
This is a replacement Traxxas Front & Rear Steel Bulkhead Tie Bar Set, and is intended for use with the Traxxas 1/16 Grave Digger Monster Jam R...
View full details
This is a replacement Traxxas GTR Shock Spring Set, and is intended for use with the Traxxas 1/16 Rally.
This is the 2nd Gear for the 2-speed for the Nitro 4-Tec.FEATURES:Black nylon colorINCLUDES:One gear 37 Teeth
Manufacturer Description This is the Replacement Carrier Drive Dog for Traxxas E-Maxx Truck.This part is located in the gearbox in between the two ...
View full details
TRA4919 Servo mounts, throttle/ brake (1) (black)
This is a replacement Traxxas Receiver Cover, and is intended for use with the Traxxas Nitro Sport 1/10 Scale Nitro Truck.
Traxxas Cush Drive Housing. Package includes one front half and one rear half. Features:Nylon Construction Includes:(1) Front Half(1) Rear Half
These are the body clips for the Traxxas E-Maxx and T-Maxx trucks.Features: Steel construction Natural polished color Includes: Twelve Body Clips...
View full details
Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch) 54-tooth spur gear (32-pitch). Traxxas spur gears let you fine-tune the performan...
View full details
Gear, 23-T pinion (48-pitch) (fits 3mm shaft)/ set screw 23-tooth pinion gear (48-pitch) fits 3 mm motor shafts and includes set screw. Traxxas pi...
View full details
This is a set of replacement stub axle nuts for the Traxxas Traxx TRA8880. Features:Factory Replacement Part Includes:(4) Stub Axle Nuts
This is a pack of four replacement Traxxas TRX-4 Bumper D-Rings with mounting screws. Features: Factory Replacement Bumper D-Rings Red in Color I...
View full details
Traxxas 48 Pitch Spur Gears are available in 45, 50 or 55 tooth count options to fine tune the gear ratio of your model. Fits: Traxxas 1/16 E-Revo...
View full details
Spur gear, 65-tooth (0.8 metric pitch, compatible with 32-pitch) 65-tooth spur gear (32-pitch). Traxxas spur gears let you fine-tune the performanc...
View full details
Traxxas Front Axles (2) Features: Steel construction Natural color Includes: Two front axles Specs: Length: 32mm (1.26") Diameter: 5mm Part C...
View full details
Decal sheet, racing sponsors Dress up your model’s body with the Traxxas Racing Sponsor Decal Sheet. The decal sheet includes over 25 different fu...
View full details
Shock shafts, steel, chrome finish (long) (2) Replacement steel shock shafts with chrome finish for Traxxas long Ultra Shocks (2). Replacement pa...
View full details
This is a set of replacement Traxxas Differential And Transmission Yokes with Hardware , and are intended for use with the Traxxas 1/16 Slash, and ...
View full details
Carriers, stub axle (rear) (2) Standard rear stub axle carriers (2) Replacement part for these models: Ford Fiesta® ST Rally Ford® Fiesta® ST Ra...
View full details
Spur gear, 50-tooth (0.8 metric pitch, compatible with 32-pitch) 50-tooth spur gear (32-pitch). Traxxas spur gears let you fine-tune the performan...
View full details
Spur gear, 54-tooth (1.0 metric pitch) 54-tooth spur gear (1.0 metric pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas...
View full details
This is the Traxxas Transmission Cush Drive Elastomer Damper for the Traxxas X-Maxx. This system requires the Cush Input Shaft (TRA7786X). Includes...
View full details
This is the Traxxas steering servo cover plate for the Traxxas Revo 3.3.Features: Nylon construction that is black in colorIncludes: One Steering S...
View full details
This is the optional 40 tooth spur gear for the Traxxas Revo monster truck. This spur gear goes on the gear box to transfer power from the clutch b...
View full details
Input shaft (slipper shaft) / spring pin Replacement input shaft (slipper clutch shaft) for Magnum 272 transmissions. Does not fit Magnum 272R tra...
View full details
Top drive gear, steel (22-tooth) Replacement 22-tooth steel top drive gear for standard Magnum 272 transmission Replacement part for these models...
View full details
Spur gear, 60-tooth 60-Tooth spur gear. Traxxas spur gears let you fine-tune the performance of your Traxxas model. Changing gear ratios can help ...
View full details
Traxxas Steering Linkage 3x20mm Turnbuckle Fits: Traxxas Slash 4x4 Traxxas Stampede 4x4
Wheel hex clips (6) Set of six wheel hex clips Replacement part for these models: X-Maxx® Ultimate X-Maxx® XRT® Ultimate XRT®
Telemetry trigger magnet holders, spur gear/ magnet, 5x2mm (1)/ 3x8mm CCS (3)/ 3x10mm CCS (3) The telemetry trigger magnet holders secures the tri...
View full details
