TRAXXAS CARS AND TRUCKS AND PARTS IN STOCK 2025

TRA9583 Traxxas Differential output cup, front or rear (hardened steel)

Traxxas Springs, shock, long (natural finish) (GTS) (0.29 rate, white stripe) (for use with TRX-4 Long Arm Lift Kit)

Lower chassis, low CG (black) Change up the color on your low-CG-equipped 2WD Slash with this accessory lower chassis. Does not fit standard chass...

Half-shafts (internal-splined (2)/external-splined (2))/ metal U-joints (4) Set of two half shafts includes internal shafts (2) and external shaft...

Traxxas Bumper mounts, front & rear/ bumper mount, rear (offset)

Traxxas Body Mount Rear/Body Mount Posts, Front (2) Features: Plastic construction Includes: One-piece Rear and two-piece Front Body Mounts Fit...

Turnbuckle, aluminum (blue-anodized), camber link, front, 39mm (1)(assembled w/rod ends)/hollow balls (2)(See part 3741A for complete camber link ...

Traxxas Servo saver/ servo saver spring/ servo horn, steering

Traxxas Roof, Body (Fits TRA9711 Body)

Traxxas Steering Blocks, Left & Right/ Caster Blocks (C-Hubs), Left & Right

Traxxas Rebuild Kit, Oil-Filled Shocks (O-Rings, Spacers, Bladders, Bottom Caps) (Renews 2 Shocks)

Traxxas Wire Harness, Led Lights (Front)/ Zip Ties (2)

TRA9552 Traxxas Carriers, stub axle (left and right)

This is a replacement Traxxas Telemetry Expander Mount for the TRX-4. Features: Factory Replacement Part Nylon Construction Includes:(1) Telemet...

Gear, 18-T pinion (32-p), heavy duty (machined, hardened steel) (fits 3mm shaft)/ set screw The heavy-duty 18-tooth (32-pitch) pinion gear is mach...

Shock tower, rear Replacement rear shock tower Replacement part for these models: Hoss® 4X4 VXL Rustler® 4X4 Ultimate Rustler® 4X4 VXL Rustler® 4X4

Traxxas replacement slide carb linkage set includes all parts in linkage set. This linkage set will not work with the older T-Maxx with the Pro .15...

TRAXXAS Linkage, sway bar, front (2) (assembled with hollow balls)/ sway bar arm (left & right)

This is the Traxxas servo mount for steering chassis crossmember.

Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws

‹¯¨Top Gear Machined 22T SRT

These are 20 Groove Middle Pulleys by Traxxas.FEATURES:Black in colorHard Plastic Construction for the Pulleys and Flanges.Metal Construction for t...

This is a pair of Traxxas Aluminum Front/Rear Bulkhead Tie Bars in Blue with a 2.5x6mm Cap Screw for the 1/16 Scale Slash 4WD, E-Revo, E-Revo VXL, ...

This is a set of four Traxxas Molded Composite Push Rods in Red with eight Hollow Balls for the 1/16 Scale Slash 4WD and E-Revo.