TRAXXAS CARS AND TRUCKS AND PARTS IN STOCK 2025

TRA7236A  Front and Rear Bumper, Green

This is a replacement Traxxas Differential Gear Set, and is intended for use with the Traxxas 1/8 Scale Funny Car. This set includes the necessary ...

Traxxas Battery Hold-Down Front/Rear 1/10 Rally VXL Features: Made of black plastic Includes: Three different pieces Fits: Traxxas Rally Traxx...

Traxxas front and rear bumpers for use on the 1/16 E-Revo VXL 4WD RTR. Plastic construction. Black chrome plated.Requires: Installation on the vehicle

This is the roof and front bumper lightbar for use on the Traxxas Summit Truck RTR.Features: Plastic construction that is chrome in colorIncludes: ...

FEATURES: Replaces missing or damaged brake cams Brake cam is blue aluminum Cam lever and grub screw are steel INCLUDES: One blue aluminum brake ca...

This is a replacement Traxxas TRX-4 Transmission Gear Set. 

Bulkhead, front & rear / differential housing, front & rear Front and rear bulkheads with front and rear differential housing covers Repl...

Hold down, battery/ hold down retainer/ battery post/ foam spacer/ angled body clip (allows for installation of taller, multi-cell batteries) The ...

Battery expansion kit (allows for installation of taller multi-cell battery packs) (Rustler®, Bandit, Stampede®) The battery expansion kit allows ...

Traxxas Springs, shock (natural finish) (GTR short) (1.19 rate, green stripe) (1 pair)

Traxxas Pinion gear, differential (12/47 ratio) (rear) (requires #10757 with either #10758 or 10760)

Stub axles, rear, heavy duty (2)/pins (2) Pair of rear heavy-duty stub axles with pins (2) Replacement part for these models: Ford Fiesta® ST Ra...

The Traxxas Long Chassis Front Bulkhead is a replacement intended for the Traxxas Rustler 4x4. However, it can also be used with 4x4 VXL kits equip...

Body mount, front & rear (black)/ body posts, 52mm (2), 38mm (2), 25mm (2), 6.5mm (2)/ body post extensions (4)/ hardware Front and rear body ...

Ball bearings, black rubber sealed (8x16x5mm) (2) Pair of 8x16x5 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal b...

Hold down, battery/ hold down retainer/ battery post/ foam spacer/ angled body clip Battery hold down and hold down retainer with battery post, ...

Gear, 23-T pinion (1.0 metric pitch) (fits 5mm shaft)/ set screw (for use only with steel spur gears) 23-tooth pinion gear (1.0 metric pitch) fits...

Traxxas Springs, shock (GTS) (front) (0.45 rate) (2)

Traxxas Springs, shock (GTS) (rear) (0.54 rate) (2)

Ball bearings, blue rubber sealed (8x16x5mm) (2) Pair of 8x16x5 mm blue rubber seal ball bearings. Blue-seal ball bearings keep dust and grime out...

TRA9583 Traxxas Differential output cup, front or rear (hardened steel)

Traxxas Springs, shock, long (natural finish) (GTS) (0.29 rate, white stripe) (for use with TRX-4 Long Arm Lift Kit)

Lower chassis, low CG (black) Change up the color on your low-CG-equipped 2WD Slash with this accessory lower chassis. Does not fit standard chass...

Half-shafts (internal-splined (2)/external-splined (2))/ metal U-joints (4) Set of two half shafts includes internal shafts (2) and external shaft...

Traxxas Bumper mounts, front & rear/ bumper mount, rear (offset)

Traxxas Body Mount Rear/Body Mount Posts, Front (2) Features: Plastic construction Includes: One-piece Rear and two-piece Front Body Mounts Fit...

Turnbuckle, aluminum (blue-anodized), camber link, front, 39mm (1)(assembled w/rod ends)/hollow balls (2)(See part 3741A for complete camber link ...

Traxxas Servo saver/ servo saver spring/ servo horn, steering

Traxxas Roof, Body (Fits TRA9711 Body)

Traxxas Steering Blocks, Left & Right/ Caster Blocks (C-Hubs), Left & Right

Traxxas Rebuild Kit, Oil-Filled Shocks (O-Rings, Spacers, Bladders, Bottom Caps) (Renews 2 Shocks)

Traxxas Wire Harness, Led Lights (Front)/ Zip Ties (2)

TRA9552 Traxxas Carriers, stub axle (left and right)

This is a replacement Traxxas Telemetry Expander Mount for the TRX-4. Features: Factory Replacement Part Nylon Construction Includes:(1) Telemet...

Gear, 18-T pinion (32-p), heavy duty (machined, hardened steel) (fits 3mm shaft)/ set screw The heavy-duty 18-tooth (32-pitch) pinion gear is mach...

Shock tower, rear Replacement rear shock tower Replacement part for these models: Hoss® 4X4 VXL Rustler® 4X4 Ultimate Rustler® 4X4 VXL Rustler® 4X4

Traxxas replacement slide carb linkage set includes all parts in linkage set. This linkage set will not work with the older T-Maxx with the Pro .15...

TRAXXAS Linkage, sway bar, front (2) (assembled with hollow balls)/ sway bar arm (left & right)

This is the Traxxas servo mount for steering chassis crossmember.

Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws

‹¯¨Top Gear Machined 22T SRT

These are 20 Groove Middle Pulleys by Traxxas.FEATURES:Black in colorHard Plastic Construction for the Pulleys and Flanges.Metal Construction for t...

This is a pair of Traxxas Aluminum Front/Rear Bulkhead Tie Bars in Blue with a 2.5x6mm Cap Screw for the 1/16 Scale Slash 4WD, E-Revo, E-Revo VXL, ...

This is a set of four Traxxas Molded Composite Push Rods in Red with eight Hollow Balls for the 1/16 Scale Slash 4WD and E-Revo.

Features:Hardened plastic constructionBlack in colorIncludes:One rear shock towerRequires:Installation on chassisTechnical Specifications:Length: 8...

This is the optional Battery Hold Down for the Traxxas Stampede 4x4 VXL.Features: Composite construction Allows installation of taller multi-cell ...