IN STOCK ITEMS

TRA5233 Slide, carburetor (slide only for TRX 2.5, 2.5R)

TRA7666 Spring, shock (red) (GTR) (0.314 rate)(1 pair)

This is a pack of four replacement LaTrax Assembled Oil-Less Shocks. Package includes four pre-built shocks and shock springs that can be used on e...

TRA7091 Gearbox halves, front & rear

This is an assembled rudder pushrod and servo horn for the Traxxas DCB M41. Includes:1x Assembled Rudder Pushrod1x Servo Horn1x 3x18mm Button Head ...

TRA5597 Sway bars (rear) (includes soft, medium, hard)

Traxxas aluminum turnbuckle front toe link features red anodized aluminum construction. Black pre-attached ball links Includes: One aluminum link S...

These are the Front Chrome Wheelsfor the Traxxas Nitro Jato Stadium Truck. Features Nylon constructionChrome PlatedFive Split Spoke Wheel PatternUs...

This is a set of four Traxxas Suspension Down Stop Screws with a 2.5mm Drill Bit for the Jato. All R/C off-road racers want as much ground clearanc...

This is a Shift Fork/Shaft for the Traxxas Revo.FEATURES:Plastic shift fork constructionMetal shift fork shaftShift fork plastic is black in colorP...

Traxxas idler gear with bearing and support for the Revo. These parts install inside the transmission. Steel idler gear construction Plastic idler ...

Suspension Arms, Right: Revo, Revo 3.3 This is the Upper and Lower Right Suspension Arm Set used in theRevo Adjustable Suspension Arm Set, TRAC534...

This is a package of flat head countersunk machine screws from Traxxas.Features: Silver metal construction Flat head Phillips drive Includes: Six...

TRA5146 Hanger, metal (T-Maxx/S-Maxx) (TRX 2.5, 2.5R)

TRA5127 Stub axle (1) (Jato) (for steel constant-velocity driveshaft)

FEATURES: Replaces damaged or worn 2-speed drive gearsGears are constructed of plastic and pre-installed on steel shaft INCLUDES: One 17 and 22 too...

This is the Replacement 43 Tooth 1st Speed Spur Gear for the Traxxas T-Maxx4WD Radio Control Monster Truck.This spur gear is installed in the trans...

Traxxas throttle brake linkage for the T-Maxx is an assortment of linkage wires for the Traxxas T-Maxx. These wires connect the servos to the engin...

Traxxas 4934 Aluminum Caps Pivot Balls (4pcs) T-Maxx  These are the Pivot Ball Aluminum Caps for the Traxxas T-Maxx4WD Radio Control Monster Truck....

Traxxas throttle and brake servo mounts for the T-Maxx 3.3 is constructed of gray plastic. Includes: Two servo mounts Specs:Length: 1-3/8" (36mm)Wi...

Traxxas 4918 Servo Mounts Front/Rear This is a pair of Steering or Shifting Servo Mounts for the Traxxas T-Maxx. These mounts are what holds the s...

This is a replacement Traxxas Receiver Cover, and is intended for use with the Traxxas Nitro Sport 1/10 Scale Nitro Truck. 

TRA4445 Fuel tank vibration cushion, rubber

These are Replacement Throttle and Brake Rod for the TraxxasGas Powered Stampede.FEATURES:Steel ConstructionINCLUDES:One Straight Rod with Z BendOn...

FEATURESSteel construction, gun metal in colorReplaces a worn or damaged idler gearINCLUDESOne 13 Tooth Idler Gear (first speed gear)REQUIREMENTSIn...

Wire, 12-gauge, silicone (Maxx Cable) (650mm or 26 inches)

Screws, 2.6x8mm flathead machine, self-tapping (hex drive) (6)

Rod guides (2)/ 3mm nylon locknuts (2)

Shock caps, aluminum (2)

Trim adjustment bracket

VTR237014 6mm x 12mm x 4mm Ball Bearing (2)

VTR234020 Suspension Arms (2), Fr/Rr: Hal

VTR234017 Upper Suspension Arm Mount FR/RR: V100

VTR234012 Ball Cup Ends: Twin Hammers

VTR234001 Front Spindles: Twin Hammers

VTR233009 Shock Spring Medium Silver (2): V100

VTR232061 Slipper Cover/Spacers & Bearing Holders: Hal

VTR232048 Diff Housing and Spacers: V100

VTR232021 Molded Drive Shaft: Twin Hammers

VTR232003 Rear Axle Tubes: Twin Hammers