This is a 2WD Gear Hub and Snap Ring for the Traxxas Nitro 4-Tec. COMMENTS: There are two spur gear pins molded into the gear hub. pjm 2/12/03 ir/jxs

Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...

Bearing block, front (supports front shaft)/belt tension adjustment shims (front/ middle)/ screws

FEATURES: Black nylon construction INCLUDES: One left chassis stiffener One right chassis stiffener REQUIRES: Installation onto vehicle. SPECS: Lef...

Traxxas Pro .15 to TRX 2.5 engine conversion has a tune Pipe, bellcrank, & Throttle Servo Horn made of plastic. Linkage wire made of steel. Spe...

Traxxas 4372 Wheel Chrome Nitro 4-Tec (2) These are the Replacement Chrome Wheels for the Electric Traxxas 4-Tec.Features: Nylon Construction Chro...

Suspension arms, front (L&R)/ ball joints (2)

FEATURES: Nylon reinforced plastic construction 0° of casterINCLUDES: -One Front Lower Suspenson MountCOMMENTS: This part mounts to the chassis and...

This is a set of replacement Traxxas Rear Stub Axle Carriers, and are intended for use with the Traxxas Nitro Rustler, and Street Sport vehicles. 

Backplate (for recoil start engines) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine

High-speed needle valve & seat assembly (w/ securing nut) Replacement part for these models: TRX® Pro .15 TRX® Pro .15 Marine

These are the Replacement 20 Tooth Idler Gears for the Traxxas E-Maxx Truck.These gears are located in the gearbox.FEATURES:Plastic constructionINC...

Servo Horns Throttle Steering

Shock Collar, Cap & Bushing: Twin Hammers

Screws 3x36mm Counter Mach

Clutch bell, hardened steel (20-tooth) (32-pitch) (N. Hawk/Buggy/Street) ¶ÿ Accessory part for these models: TRX Pro .15

Complete Hardware Set: 1/24 4WD Barrage