ALL TRAXXAS

Wiring harness for RX Power Pack, Traxxas® nitro vehicles except Revo® (includes on/off switch and charge jack) This custom wiring harness simplif...

Set (grub) screws, 3mm hardened (12)

Screws, 4x10mm countersunk machine (hex drive) (6)

Traxxas 1000mAh 2S 7.4V 20C LiPo Battery (fits TRX-4M)

4000mah 11.1v 3-Cell 25C LiPo Battery Traxxas Certified iD®-equipped LiPo batteries provide the punch and on-demand power to reach the top spee...

This is a pair of Traxxas pre-assembled rims and tires, the 3.8" 6 spoke wheels have a 17mm splined hex and the Talon EXT tires are pre-glued to th...

This is a Traxxas front and rear Skidplate.Features: Molded composite plastic construction and reduces damage to underside of chassis and other com...

Driveshaft assembly, front & rear, 6061-T6 aluminum (blue-anodized) (2) Replace the standard composite driveshafts in your 1/18 scale LaTrax Pr...

Slash 4X4 Low-CG (Low Center of Gravity) Conversion Kit Everything to convert your Slash 4X4 Performance-proven by the Slash 4X4 Ultimate and 1/1...

Rod ends, Revo® (large) with hollow balls (12) Set of twelve large Revo®-style rod ends with hollow balls. Replacement part for these models: 4-...

Traxxas tune pipe coupler and exhaust deflector set for the Revo. Allows for a connection between the Exhaust Header and the Tune Pipe. Silicone co...

Screws, 2.5x8mm cap-head machine (6) Set of six 2.5x8 mm cap-head machine screws with hex-drive heads Replacement part for these models: 1/16 E-...

Screws, 4x15mm countersunk machine (hex drive) (6)

Gear set (for 2080 waterproof micro servo) Replacement gear set for standard 2080 micro servo. Does not fit 2080A or 2080X servos.

Roll bar (assembled with LED lights)/ mounts (front (2), rear (left & right))/ 2.6x12mm BCS (self-tapping) (4) (fits #9212 or 9230 series bodi...

Nuts, 4mm nylon locking (10) Set of ten 4 mm Nylon locking nuts Replacement part for these models: Bandit® VXL Bandit® BIGFOOT® No. 1 Officially...

A New Maxx Legacy Begins The Traxxas X-Maxx® is a giant that forever changed the face of RC monster trucks. Its radical cutting-edge design, ma...

This is the Traxxas Transmission Cush Drive Elastomer Damper for the Traxxas X-Maxx. This system requires the Cush Input Shaft (TRA7786X). Includes...

Servo horn, steering, metal/ 3x14 BCS (1) Replacement steel servo horn for TRX-4® and TRX-6® models. Replacement part for these models: TRX-4® 1...

Sensor, RPM (long)/ 3x4mm BCS (1)/ 3x4 GS (1) The RPM sensor plugs directly into your TQi™ receiver to provide real-time speed and RPM data while ...

Driveshaft, steel constant-velocity (heavy duty, shaft only, 160mm) (1) (replacing #7750 also requires #7751X, #7754X and #7768 or #7768R) Heavy-d...

Mount, tie bar, front (1)/ rear (1) Front and rear tie bar mounts Replacement part for these models: X-Maxx® Ultimate X-Maxx® XRT® Ultimate XRT®

IF NOT IN STOCK  REORDER  RPM73162 OR  RPM73165 OR RPM73164 OR RPM73169     These are the left and right axle carriers for use on the Traxxas 1/16 ...

These are the pivot balls and pivot ball caps for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles.Features: Steel constructed pivot balls wit...

Drive hub, center, rear (1)/ 4x3 GS (1) Rear center drive hub with 4x3 mm grub screw Replacement part for these models: Ford Fiesta® ST Rally Fo...

This is an optional Traxxas CV Driveshaft Set, and is intended for use with the Traxxas T-Maxx 3.3, Revo 3.3, E-Maxx and E-Revo trucks. Traxxas Ste...

This is the Exo-carbon wing for the Traxxas Revo 3.3. This part attaches to the rear of the body.Features: Plastic construction, exo-carbon finish ...

Carrier, differential (heavy duty)/ x-ring gaskets (2)/ ring gear gasket/ bushings (2)/ 6x10x0.5 TW Heavy-duty differential carrier with x-ring ga...

Gear, 16-T pinion (48-pitch) / set screw 16-tooth pinion gear (48-pitch) fits 3 mm motor shafts and includes set screw. Traxxas pinion gears let y...

Differential kit, center (complete) (aluminum carrier) Replace your Traxxas vehicle’s stock slipper clutch with this Pro-Built high-performance ce...

This is a Traxxas LED front bumper light bar for the TRX-4 sport body. Requires: TRA8028 Power Supply Accessory part for these models: TRX-4 1979 ...

Traxxas Mounted Wheelie Bar Tires/Wheels Blue (2) Features: Machined blue aluminum ball bearing equipped wheels Rubber Tires Includes: Two rubbe...

O-ring and seal set, carburetor/ O-rings: 2x1mm (3), 10x1mm (4), 2.5x1.15mm (2), 6.2x1.2mm (1)/ 5x.9mm O-ring installation tool/ 5.3x7.8x.6mm crus...

Carburetor, complete (minus air filter assy.) (TRX® 2.5, 2.5R, 3.3 composite slide) The complete slide carburetor comes fully assembled and ready ...

This is a pair of 173mm molded composite plastic toe links for the Traxxas X-Maxx Monster Truck. Features: Molded composite plastic construction S...

This is the rear bulkhead for use on the Traxxas 1/16 E-Revo and Slash vehicles.Features: Nylon construction that’s black in colorIncludes: Two Re...

This is a replacement Traxxas Rear Differential Housing, and is intended for use with the Traxxas Slash 4x4 short course truck. Features: Nylon Co...

Spur gear, 76-tooth (48-pitch) (for models with Torque Control slipper clutch) 76-tooth spur gear (48-pitch) for Torque Control slipper clutches...

ALUMINUM CASTER BLOCKS: Traxxas aluminum caster blocks improve the appearance, ruggedness, and control on the your Traxxas model. In addition to t...

XL-2.5™ Waterproof FWD/REV ESCwith Low Voltage Detection (LVD) Designed and engineered by Traxxas, the XL-2.5 Electronic Speed Control delivers smo...

Videos 2.4GHz radio system Quad-rotor thrust with auto-leveling 6-axis flight system Four high-output motors High-tech molded frame Integ...

Traxxas Wheel Weights, Brass (31 Grams Each) (2) (Fits TRA9781 Series Wheels)

Traxxas Display Stand (155mm Wheelbase)

Fuel line (610mm or 2ft) 24" fuel line Replacement part for these models: Jato® Nitro Rustler® Nitro Slash Revo® Slayer® Pro 4X4 T-Maxx® Access...

The Traxxas Pro Scale Advanced Lighting Control System w/Power Module & Distribution is a great way to add scale realistic lights to you TRX-...

Tires & wheels, assembled, glued (black wheels, dual profile (2.8" outer, 3.6" inner), Sledgehammer® tires, foam inserts) (2) (17mm splined)...

This is a Traxxas LED roof light bar for the TRX-4 sport body. Requires: TRA8028 Power Supply Replacement part for this model: TRX-4 Equipped with ...

Wheel hubs, splined, 17mm (blue-anodized) (4)/ 4x5 GS (4), 3x14mm pin (4) Set of four 17 mm blue-anodized aluminum wheel hubs combine high-profile...