ALL TRAXXAS

Traxxas Heat Sink, Titan 87T Motor (6061-T6 Aluminum, Blue-Anodized)

Input gear, 22-tooth/ input shaft (transmission) (heavy duty) (fits Bandit®, Rustler®, Stampede®, Slash® 2WD) The heavy-duty input shaft features...

Servo, micro, waterproof The 2080A waterproof micro servo gives you the freedom to drive in rain, mud, and snow. Replacement part for these mode...

Heavy-Duty X-Maxx® Suspension Arm Heavy-duty X-Maxx lower suspension arms utilize our latest proprietary composite material for extreme durabilit...

Mount, tie bar, front (1)/ rear (1)/ suspension pin retainer, front or rear (2) Front and rear tie bar mounts with front and rear suspension pin r...

Oil, differential (500K wt) (0.7 oz (20cc)) Thick 500k weight differential oil adds significant locking action to your differentials. Traxxas perf...

Balance Lead Adapter (2938X)The Traxxas Balance Lead Adapter connects batteries to the accessory LiPo Cell Voltage Checker (2968) to check battery ...

Videos LaTrax Alias Quad-Rotor Ready-To-Fly Helicopter 2.4GHz radio system Quad-rotor thrust with auto-leveling 6-axis flight system Four h...

MODEL SPECS Name: Slayer® Pro 4X4 Type: Short Course Truck Speed: 45 mph, 50+ with optional 17-tooth clutch bell (5217), sold separatel...

Body reinforcement set (fits #7711 body) X-Maxx® body reinforcements provide added protection for your truck during extreme driving. These high-st...

These are the Traxxas 17mm Serrated Splined Wheel Nuts, replacement part for the X-Maxx and can also be used on the VXL Revo. Features: Aluminum c...

This is a replacement Traxxas 9 Tooth LaTrax Pinion Gear, for use with the LaTrax 1/18 Desert Runner and 1/18 Teton. Features:Factory Replacement G...

This is the clear LED lightbar in chrome for the Traxxas Stampede 4x4 VXL.Features: Four clear LED lights in chrome finish plastic housingsIncludes...

Cush drive key/ pin/ elastomer damper Cush drive key includes pin and elastomer damper Replacement part for these models: E-Revo® VXL Brushless ...

This is a pair of Traxxas optional red aluminum pushrods for the rocker arms on the REVO. These go between the rocker arms and the lower suspension...

Screw pins, 4x13mm (with threadlock) (4) Set of four 4x13 mm screw pins with hex-drive heads and threadlock Replacement part for these models: R...

This is the set of axle pins for the Traxxas T-Maxx 4WD RTR Monster Truck. These pins go through the stub axles on each wheel, the wheel hubs are t...

Traxxas Skid Plate Front Plastic Gray Features: Attaches to and protects chassis and supports the front bulkhead Skidplate is gray in color Inclu...

CS 3x10 flathead (hex drive) Set of four 3x10 mm flat-head machine screws with hex drive heads Replacement part for these models: 4-Tec® 2.0 AWD...

This is the optional glow plug wrench from Traxxas.Features: Features aluminum construction and a dull silver color Will work on 7mm and 8mm glow ...

Cover, gear/ rubber gear cover plug/ 3x6 RM (2) Replacement gear cover for Magnum 272 transmissions. Includes clutch nut adjustment cover plug and...

Spring pre-load spacers: 1mm (4)/ 2mm (2)/ 4mm (2)/ 8mm (2) Change the ride height on your vehicle with these spring pre-load spacers for Traxxas ...

TRA3742 Shoulder screws, steering bellcranks

Screws, 3x10mm caphead machine (hex drive) (6)/ lockwashers (6)/ hex wrench Set of six 3x10 mm cap-head machine screws with hex drive heads and lo...

Front axles (2)

Traxxas Driveshaft assembly, rear, extreme heavy duty with 6mm axle (1)/ screw pin (1) (left or right) (fully assembled, ready to install) (for use...

This is the Motor Mount Washers and Screws for the Traxxas X-Maxx. Features: Aluminum Construction Blue in Color Exact Fit   Includes: (4) W...

Wheel nuts, splined, 17mm, serrated (red-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug n...

This is a replacement Traxxas Maxx Driveshaft Assembly, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.   Features: Factory Replac...

Push rod (steel), heavy duty (2) (assembled with rod ends) Replacement heavy-duty steel push rods for E-Revo® VXL. Rods come assembled with rod en...

This is a set of two replacement stub axle carriers from Traxxas intended for the Maxx. Features: Traxxas Quality and Precision Factory Replacemen...

Battery, Series 4 Power Cell, 4200mAh (NiMH, 6-C flat, 7.2V) Traxxas 4000-series Power Cell NiMH battery packs provide 25% greater capacity tha...

Transmitter, TQ 2.4GHz, 2-channel (transmitter only) Switch on the power and drive! That's all there is to it with the TQ™ 2.4GHz radio. There are...

This is a Traxxas Front/Rear Steel Center Assembled Constant-Velocity Driveshaft Set for the E-Revo VXL Brushless. These Constant Velocity Drivesha...

Chassis top brace Replacement X-Maxx® chassis top brace Replacement part for these models: X-Maxx® Ultimate X-Maxx®

XL-5HV 3s Electronic Speed Control, waterproof (low-voltage detection, fwd/rev/brake) The high-voltage XL-5™ HV electronic speed control for TRX-4...

Nuts, 4mm flanged nylon locking, serrated (black) (10) Set of ten black flanged nylon locking nuts Replacement part for these models: 4-Tec® 2.0...

This is a replacement Traxxas 1/16 Steel Center Drive Shaft Set, and is intended for use with the Traxxas 1/16 scale family of 4WD vehicles. These ...

This is the complete differential assembly for use on the Traxxas 1/16 E-Revo and Slash VXL vehicles. Not for use on 1/10 scale vehicles.Features: ...

Half shafts, heavy duty (external splined (2)/ internal splined (2))/ metal u-joints (4) Set of two heavy-duty half shafts includes internal shaft...

This is a optional Traxxas Aluminum Steering Block Set, and is intended for use with the Traxxas Slash 4x4 truck. Precision-machined for total stee...

This is a pack of two replacement Traxxas Pre-Mounted Robby Gordon Rear Tire & Wheels, and is intended for use with the Traxxas Slash Robby Gor...

Servo horn (with built-in spring and hardware) (for Summit locking differential) Shift servo horn with built-in spring tensioner Replacement part...

This is the Traxxas set of four Anodized 17mm Splined Wheel Hubs, (4). These Splined Wheel Hubs are red colored and compatible with the Traxxas Sla...

This is the upper & lower left front suspension arm set for the REVO from Traxxas.Features: Durable black nylon constructionIncludes: Upper and...

Suspension arms upper (1)/ suspension arm lower (1) (right front) Upper and lower front right suspension arms Replacement part for these models: ...

Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch) (for center differential) The 54-tooth spur gear (32-pitch) fits the 6814 center ...