Anchoring pins with locknuts (4)/ plastic thumbscrews for upper deck (4)

Traxxas tie-rods and upper camber rods are constructed of steel. Includes: Four Turnbuckles Two Draglinks. These turnbuckles are used on the steeri...

TRA4919 Servo mounts, throttle/ brake (1) (black)

TRA3959 Spur gear, 62-tooth (0.8 metric pitch, compatible with 32-pitch)

These are the body clips for the Traxxas E-Maxx and T-Maxx trucks.Features: Steel construction Natural polished color Includes: Twelve Body Clips...

Spur gear, 54-tooth (0.8 metric pitch, compatible with 32-pitch) 54-tooth spur gear (32-pitch). Traxxas spur gears let you fine-tune the performan...

Spur gear, 50-tooth 50-tooth spur gear (48-pitch) with telemetry magnet holder. Traxxas spur gears let you fine-tune the performance of your Traxx...

Traxxas Tie-down straps (front & rear), boat trailer

Body clip (mounting clip), angled, 90-degrees (black) (10) 90-degree black mounting clips are perfect for battery latches, making battery access q...

This is a replacement Traxxas Maxx Transmission Input Shaft, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck. Features:Factory Repl...

This is a pack of 12 heavy duty body clips for Traxxas vehicles. Features: Black Color Curved End to Ease Removal Includes:(12) Body Clips Body ...

Traxxas Latch knob, hatch (4)

These are the 6x9.6mm X-ring Seals for the Traxxas Unlimited Desert Racer. Includes 4 seals.

This is the Fuel Cap Pull Ring/Shut-Off Clamp set for the Traxxas Revo.FEATURES:Plastic constructionSimple, squeeze-clamp restricts fuel line for e...

This is a replacement Traxxas Gear Cover, and is intended for use with the Traxxas 1/10 Rally. Features:Factory Replacement Gear Cover Includes:(1...

This is a Gearbox Brace for the Nitro Rustler and the Nitro Sport. Features Black Plastic Construction Includes One Brace Requires Traxxas Nitro Ru...

Traxxas 48P Pinion Gear (29)

Hex wheel hubs, steel (2)/ axle pins (2.5x12mm) (2) 14 mm steel wheel hubs provide superior strength and durability and won't round off. Includes ...

Screws, 2.6x8mm flathead machine, self-tapping (hex drive) (6)

This is a pack of four replacement Traxxas TRX-4 Bumper D-Rings with mounting screws. Features: Factory Replacement Bumper D-Rings Gray in Color ...

This is the Traxxas 4-Tec 2.0 Motor Plate. This fits all 4-Tec 2.0 cars, including the Ford GT and Mustang GT.Stock Replacement On4-Tec 2.0 VXL Cha...

This is the Shock Mount Lower and Wire RetainerFor the Traxxas Funny CarsFEATURES:Black plasticINCLUDES:One shock mountOne wire retainerCOMMENTS:Th...

Shaft, slipper clutch (w/ roll pin)

This is the Traxxas Gear, 26-T pinion (48-pitch, 2.3mm shaft)/ set screw. This is Traxxas part number 7040Part Number: 7040 / TRA7040Fits1/16 E-Rev...

These are the Traxxas 4-Tec 2.0 Red Front and Rear Brake Calipers. These work on all 4-Tec 2.0 cars, including the Ford GT and Mustang GT.Stock Rep...

This is a 6 pack of Traxxas 4X6mm button head screws.Features: Steel construction that is black in color Button head design Includes: Six 4X6mm b...

Screws, 4x35mm button-head machine (hex drive) (6)

Spur gear, 70-tooth 70-tooth spur gear (48-pitch). Traxxas spur gears let you fine-tune the performance of your Traxxas model. Changing gear rat...

Main diff gear w/side cover plate & screws

Traxxas Gear Shaft Primary Features: Replaces stock gear shaft. Constructed of steel. Includes: One gear shaft  Part Compatibility: Traxxas S-...

Screws, 2.5x14mm cap-head machine (hex drive) (6)

Screws, 4x25mm button-head machine (hex drive) (6)

Traxxas Top Drive Gear, Steel (21-Tooth)

These are the Traxxas Front/Rear Plastic Non-Adjustable Camber Links for the Telluride 4x4.Features: Grey colored Made of tough plastic Fits the f...

Ball bearings, black rubber sealed (5x8x2.5mm) (2) Pair of 5x8x2.5 mm black rubber seal ball bearings. A step above blue-seal bearings, black-seal...

TRA5282 Screws, 3x12mm button-head machine (6)

This is a package of six 4x18mm Button Head Machine Screws from Traxxas.FEATURES:Steel construction, black in colorINCLUDES:Six 4x18mm Button Head ...

Idler gear (30-tooth)

Shock shafts, steel, chrome finish (X-long) (2)

Servo case (for 2055 servo)

Traxxas Spur gear, 47-tooth (0.8 metric pitch, compatible with 32-pitch)

This is a 48 pitch 78 tooth spur gear from traxxas. The gear is molded fromwhite plastic. This spur gear is for use with Traxxas' slipper clutch.In...

These are the two Wheels for the #6978 Wheelie Barused on the NHRA Funny Car Race Replica from Traxxas, TRAD69**.FEATURES:Plastic construction, bla...

Differential spur gear & drive gear

This is the 1st Speed Output Gear 36T for the Traxxas E-Maxx Truck.This gear is located in the gearbox.FEATURES:White nylon constructionINCLUDES:On...

TRA4681 SPUR GEAR 81T 48P

Side nerf bars