TRA5830 Chassis conversion kit, low CG (Slash)
TRAXXAS
Slash® 2WD Low-CG (Low Center of Gravity) Conversion Kit #5830 Everything to convert your Slash 2WD The Low-CG Conversion Kit lowers your Slash’...
View full details
Slash® 2WD Low-CG (Low Center of Gravity) Conversion Kit #5830 Everything to convert your Slash 2WD The Low-CG Conversion Kit lowers your Slash’...
View full details
Just like the heavy-duty suspension arms, X-Maxx roof skid plates use the toughest composite material. Whether you're sending it at the skate park,...
View full details
This is a front and rear differential housing for the Traxxas X-Maxx Monster Truck. Features: Molded composite plastic construction Fastens to fro...
View full details
Ultra Shocks (grey) (xx-long) (complete w/ spring pre-load spacers & springs) (rear) (2) Traxxas oil-filled Ultra Shocks utilize X-rings for a...
View full details
Gear set, differential, metal (output gears (2)/ spider gears (4)/ ring gear, 35T (1)/ 2x14.8mm pin (1)) Replace the standard plastic gears in you...
View full details
TRA3752 Stub axle carriers (2) (requires 5x11x4mm bearings) ***** if not in stock order RPM80385 or RPM80382 Stub axle carriers (2) (requires 5x...
View full details
Screws, 3x12mm button-head machine (hex drive) (6) 3x12 mm button-head machine screws with hex drive heads. Set of six. Replacement par...
View full details
Wheel hubs, hex (front) (tall offset) (2)/ axle pins (2.5x10mm) (2) 12 mm tall-offset wheel hex hubs with 2x10 mm axle pins (2) Replacement part ...
View full details
Spring retainers, upper & lower (2)/ piston head set (2-hole (2)/ 3-hole (2)) Upper and lower spring retainers for Ultra Shocks with 2-hole pi...
View full details
Ring gear, differential/ pinion gear, differential 1/16 scale differential ring and pinion gears Replacement part for these models: 1/16 E-Revo®...
View full details
This is a replacement Traxxas Differential Gear Set, differential (output gears (2), spider gears (2), spider gear shaft, and carrier support) and ...
View full details
Driveshafts, steel constant-velocity (assembled), front or rear (4) (for use with #8995 WideMaxx® suspension kit) (requires #8654 series 17mm spli...
View full details
Tie bar, fiberglass The fiberglass tie bar strengthens the front bulkhead and suspension arms. Requires #2640 suspension pins to complete installa...
View full details
Stub axles, rear (2) Set of two replacement rear stub axles Replacement part for these models: Bandit® VXL Bandit® BIGFOOT® No. 1 Officially Lic...
View full details
Battery, Power Cell, 3000mAh (NiMH, 7-C hump, 8.4V) Traxxas 3000-series Power Cell NiMH battery packs provide excellent run times and “punch” a...
View full details
Slipper pressure plate & hub (aluminum alloy) Replacement standard-duty aluminum alloy pressure plate and hub. Use with 5552X standard-duty cl...
View full details
This is a Traxxas front lower bulkhead.Features: One-piece molded composite plastic construction Holds the steering, differential, skidplate and l...
View full details
Bumper, front Front bumper Replacement part for these models: X-Maxx® Ultimate X-Maxx®
Air filter and pre-filter inserts, foam (high-volume) (3) (pre-oiled, assembled) (use with #5266 filter body) (TRX® 2.5, 2.5R, 3.3) Pack of three ...
View full details
Bulkhead (front) (grey) Gray front bulkhead Replacement part for these models: Bandit® VXL Bandit® Nitro Rustler® Nitro Slash Rustler® VXL Rustl...
View full details
Bulkhead, front (upper and lower) Front upper and lower bulkhead halves Replacement part for these models: Maxx® Slash® Maxx®
Housings, differential, front Front differential housing halves Replacement part for these models: Ford Fiesta® ST Rally Ford® F-150® Raptor R™ ...
View full details
Shocks, GTR xx-long blue-anodized, PTFE-coated bodies with TiN shafts (fully assembled, without springs) (2) 1/10 scale XX-long GTR shocks represe...
View full details
XL-5 Electronic Speed Control, waterproof (land version, low-voltage detection, fwd/rev/brake)
Wire harness, series battery connection (compatible with Traxxas High Current Connector, NiMH only)
Traxxas 7730 X-Maxx Right Lower Suspension Arm This is a replacement Traxxas X-Maxx Right Lower Suspension Arm. Features: Factory Replacement Part...
View full details
Shock tower, front (left & right halves) Front shock tower halves Replacement part for these models: X-Maxx® Ultimate X-Maxx®
Body mounts, front & rear/ 3x15mm BCS (1)/ 3x12mm shoulder screw (2)/ 3x10mm flat-head machine screw (6)/ 3x15mm flat-head machine screw (2) F...
View full details
Rebuild kit, oil-filled shocks (o-ring, bladder, piston, shaft guide, E-clips, shock cap, shock rod end) renews 2 shocks Rebuild kit for LaTrax Te...
View full details
Steering blocks, left & right Steering blocks, left & right Replacement part for these models: Ford Fiesta® ST Rally Ford® Fiesta® ST Ra...
View full details
Driveshaft assembly, front or rear (2) Set of two driveshaft assemblies fit front or rear Replacement part for these models: 1/18 LaTrax® Desert...
View full details
Velineon 3500 Brushless Motor The Velineon® 3500 kV brushless motor uses ultra high-temperature Neodymium magnets, high-speed ball bearings, and a...
View full details
This is a Traxxas 61-Tooth Spur Gear factory replacement for the 1/18 scale LaTrax Desert PreRunner and LaTrax Teton. Includes: 1 61 tooth spur gear
Screws, 3x20mm button-head machine (hex drive) (6) 3x20 mm button-head machine screws with hex drive heads. Set of six. Replacement part for thes...
View full details
Screws, 3x6mm button-head machine (hex drive) (6) 3x6 mm button-head machine screws with hex drive heads. Set of six.
Traxxas Top Fuel Power Plus 33% Nitro Fuel (One Quart)
We invite you to join our mailing list to receive specials and promotions.
EMAIL: sales@bigboyswithcooltoys.ca
STORE LOCATION: OR-
TEXT 647-321-1965
Need help ONLINE ?
text online support MESSAGES WILL BE ANSWERED
from 11am to 4pm - EST- 7 DAYS A WEEK
** Response times From senior staff 2 TO 3HRS