Traxxas pair of driveshafts, outside U-joint is lubricated and sealed by a rubber boot to protect it from dirt and grime U-joint pins are held capt...
View full details
Traxxas rear plastic skidplate for the T-Maxx attaches to and protects chassis and supports the rear bulkhead. Skidplate is gray in color INCLUDES:...
View full details
TRA4914R Body mount posts, front (2)/ body mount, rear/ body mount screw pins (4)
Connector, wiring harness (EZ-Start® and EZ-Start® 2) Replacement wiring harness for the 4570 EZ-Start® and 5270R EZ-Start® 2 system. Replacement...
View full details
Flywheel (N. Rustler/Sport/Stampede/T-Maxx/Revo/Jato/Slayer) Replacement part for these models: Nitro Rustler® Revo® T-Maxx® TRX® 2.5R TRX® 3.3 T...
View full details
Air filter (complete with rubber base & foam insert) Replacement part for these models: TRX® Pro .15 Accessory part for these models: TRX® ...
View full details
Traxxas Cap Head Machine Screw 3x32mm (6) Features: Black finish Steel construction Cap head design Includes: (6) 3X32mm cap head machine screws...
View full details
These are the replacement bulkhead cross braces for the Traxxas E-Maxx. These Braces are located in between the bumper mounts.Features: Black nylon...
View full details
VXL-3m Electronic Speed Control, waterproof (brushless)
Wiring harness for RX Power Pack, Revo® (includes on/off switch and charge jack) Wiring harness for Revo and Slayer rechargeable receiver power pa...
View full details
Gear, 21-T pinion (48-pitch) / set screw 21-tooth pinion gear (48-pitch) fits 3 mm motor shafts and includes set screw. Traxxas pinion gears let y...
View full details
This is an optional Traxxas Aluminum Drag Link, intended for use with Traxxas Slash 4x4, Rustler 4x4 and Stampede 4x4 models. This machined alumin...
View full details
Suspension pins, inner, front or rear, 4x67mm (hardened steel) (2) Two 4x67 mm hardened steel inner suspension pins fit front or rear Replacement...
View full details
TRA9579R Traxxas Ring gear, differential/ pinion gear, differential (machined) (front or rear)
This is an optional pack of four Traxxas Fender Extensions, intended for use with TRX-4 and TRX-6 Kits. Includes: (4) Fender extensions (24) 3x8...
View full details
Traxxas Body, Maxx V2 (clear, requires painting)/ window masks/ decal sheet (fits Maxx V2 with extended chassis (352mm wheelbase))
This is a set of two Traxxas Window Nets intended for the Unlimited Desert Racer. Note: Pictures are for illustrative purposes only, no vehicles ar...
View full details
Traxxas Hoss LED Light Set with Power Supply. This optional complete LED light kit allows you to add lights to the front and rear of your Traxxas ...
View full details
This is an optional Traxxas Rustler 4x4 and Slash 4x4 LCG Chassis Red Brace Kit. This heavy-duty chassis brace fits Slash 4X4 models equipped with...
View full details
This is a replacement Traxxas Front Bulkhead, and is intended for the Traxxas Rustler 4x4 and Slash 4x4 vehicles. Features: Factory Replacement Pa...
View full details
Driveshaft, center, 6061-T6 aluminum (green-anodized) Traxxas designed this one-piece driveshaft out of tough 6061-T6 aluminum to be both strong a...
View full details
Differential output yoke assembly, extreme heavy duty (2) (left or right, front or rear) (assembled with external-splined half shaft)/ screw pin (...
View full details
Speed Bit Set, hex driver, 4-piece straight (1.5mm, 2.0mm, 2.5mm, 3.0mm), 1/4" drive Traxxas precision-ground, hardened-steel hex bits fit jus...
View full details
This is a Traxxas TRX-4 Two Speed Conversion Kit. This is a replacement part for any TRX-4 equipped with a 2 speed transmission, as well as an opti...
View full details
Revo 3.3 powered by stock TRX© 3.3 Racing EngineEight-Time Winner: RC Pro Series 2004-2009, ROAR 2006-2007 Extreme Power!Fueled by Passion.Where ...
View full details
Push bar, bumper (chrome) (fits #8069 bumper) Give your truck a rugged new look with this chrome bumper push bar. Fits 8069-series front bumper. ...
View full details
Box, receiver (sealed)/ foam pad/ 2.5x8mm CS (4)/ 3x10mm CS (2)Replacement part for these models:Rustler 4X4 VXLRustler 4X4
This is a replacement wing for the Traxxas Rustler 4x4. Features: Factory Replacement Part Available in: Black, White, Green, Blue, Orange, and Re...
View full details
This is a replacement Traxxas 96mm Unlimited Desert Racer Steel Constant-Velocity Driveshaft Bone. Features:Factory Replacement Part Includes:(1) D...
View full details
Dual cooling fan kit (with shroud), Velineon 1200XL motor
This is replacement Progressive Rear Shock Springs for the 2WD Slash. Features: Metal construction Pink in color Includes: (2) Shock Sprin...
View full details
This is a replacement Traxxas X-Maxx 13 Tooth Front Differential Pinion Gear. Features:Factory Replacement Part Includes:(1) Front Differential Pin...
View full details
Shock caps, GTX shocks/ spring perch/ adjusters/ 2.5x14 CS (2) (for 2 shocks) Pair of GTX shock caps with spring perches (2), adjustment rings (2)...
View full details
WHEEL HUBS, HEX (4) Set of four 12 mm hex wheel hubs Replacement part for these models: 1/18 LaTrax® Desert Prerunner 1/18 LaTrax® Teton®
This is the Traxxas Gearbox housing/ motor plate.. This is Traxxas part number 7590XPart Number: 7590X / TRA7590XFitsLaTrax SSTLaTrax Teton
This is a replacement Traxxas GTR Shock Cap & Spring Retainer Set. These parts are compatible with Traxxas GTR Long and XX-Long shocks (TRA7461...
View full details
Rebuild kit, GTR long/xx-long shocks (x-rings, bladders, pistons, piston nuts, shock rod ends, hollow balls) (renews 2 shocks) The 1/10 scale GTR ...
View full details
This is a replacement Traxxas Low-CG Chassis, and is intended for use with the Traxxas 1/10 Rally Racer and the Slash 4x4 Ultimate 1/10 scale short...
View full details
Traxxas pair of shock springs for the 1/16 Summit with a blue spring rate. Spring,shock(GTR) for 1/16 Summit. Requires: Installation onto shocks Sp...
View full details
This is a set of two Traxxas BFGoodrich Mud-Terrain TA Tires, Pre-Mounted on SCT Split-Spoke Wheels. These are intended for use on the front and re...
View full details
This is a set of two Traxxas Progressive Rate Front Shock Springs, and are intended for use with the Traxxas Slash 4x4. The Slash 4X4’s fully adjus...
View full details
TRA6838X Shock tower, rear, 7075-T6 aluminum (blue-anodized) Optional Aluminum Rear Shock Tower for the Traxxas Slash 4x4 FEATURES: 7075-T6 blue an...
View full details
This is the Mounts for the Traxxas RPM Sensor (Nitro Engines). Features: Plastic and metal construction Includes: (3) Different plasti...
View full details
Save 45%
This is an optional Traxxas "Short" Temperature & Voltage Sensor. Temperature data is critical to monitoring performance, gauging the effects o...
View full details
This is a set of two Traxxas Standard Compound Kumho Venture MT Tires, Pre-Mounted on SCT Split-Spoke Wheels. This tire set is intended for use on ...
View full details
Tire & wheel assy, glued (SCT, black, orange beadlock wheels, SCT off-road racing tires, foam inserts) (2) (2WD Front) Pair of SCT off-road ti...
View full details
