Traxxas 7668X Wheel Nut Washer Aluminum Orange 3x12mm CS (4) LaTrax Teton / SST These are the Wheel Nut Washers for the LaTrax Teton Monster Truck ...
View full details
This is a replacement Traxxas Unlimited Desert Racer Motor Mount, with two included pins. Features:Factory Replacement Mount Includes: (1) Motor M...
View full details
This is the front bulkhead for use on the Traxxas Summit Truck RTR.Features: Nylon construction that is black in colorIncludes: One Front Bulkhead ...
View full details
This is the Battery Charger for the optional NiMH Batteryused in the Traxxas TQi Docking Base.FEATURES:Charges the optional Traxxas #3037 NiMH batt...
View full details
Bulkhead, Rear (Left & Right Halves) for Summit Replacement Part For: Summit (Model# 56076-4)
This is a replacement Traxxas Center Differential Gear Set, and is intended for use with the Traxxas Slash 4x4.
Features: Clear molded polycarbonate construction Trimmed out wheel arches and body post holes Includes: Latrax Teton Clear Body with Decal Sheet...
View full details
FEATURES: Constructed of aluminum. INCLUDES: One Traxxas Exhaust Header Set for the Nitro 4-Tec and the Nitro Sport with: One Pipe Two 3mm x 25mm S...
View full details
Turnbuckles, titanium 94mm (front tie rods) (2)/ billet aluminum wrench
Traxxas 7541 LaTrax Rally Bushings 4x8x3mm (2) 6x10x3mm (8) 8x12x3.5mm (5)This is the Bushing Set for the Latrax Rally Car from Traxxas.FEATURESNyl...
View full details
Input shaft/ drive gear assembly, lightweight (18/ 13-tooth top gear) (hard-anodized/PTFE-coated 7075 T6 aluminum gears)
This is the black wing for the Traxxas Revo 3.3. This part attaches to the rear of the body.Features: Plastic construction that’s black in colorInc...
View full details
These are the Traxxas Premounted Off-Road Monster Truck Tires on 5-Spoke Wheels for the LaTrax Teton Monster Truck.Features: Black colored Plastic...
View full details
Shock caps, aluminum (blue-anodized) (4) (fits all Ultra Shocks) Aluminum shock caps are great way to boost the durability and style of any Traxxas...
View full details
TRA9490X Traxxas Plate, motor, blue (4mm thick) (aluminum)
TRA9490R Traxxas Plate, motor, red (4mm thick) (aluminum)
TRA9096 Traxxas Bumper, front (with LED lights) (replacement for #9035)
This is the replacement primary clutch assembly for the Traxxas Revo. This part is located within the two-speed transmission.Features: Aluminum and...
View full details
FEATURES: Black plastic constructionINCLUDES: Two Gearbox halves (Front and Rear) One 40mm Guide Pin Five 3x12mm Roundhead Self-Tapping Screws Two ...
View full details
This is a set of Dual Profile Tires for the Traxxas Monster Jam series.FEATURES:Rubber construction, split vee designINCLUDES:Two Dual Profile Tire...
View full details
These are the optional aluminum push rods for the Traxxas Slayer Pro 4WD Short Course Nitro RTR.Features: Aluminum construction with Nylon rod ends...
View full details
This is a pair of Traxxas optional red aluminum pushrods for the rocker arms on the REVO. These go between the rocker arms and the lower suspension...
View full details
Driveshaft assembly (1), left or right (fully assembled, ready to install)/ 4x15mm screw pin (1) The fully-assembled driveshaft comes complete and...
View full details
This is the Replacement Backplate for the Traxxas 2.5 engine.This backplate is used on the 2.5 equipped with EZ starter.FEATURES:Aluminum construct...
View full details
Wheel nuts, splined, 17mm, serrated (black-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug n...
View full details
Wheel nuts, splined, 17mm, serrated (red-anodized) (4) Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug n...
View full details
Turnbuckles, aluminum (red-anodized), toe links, 59mm (2) (assembled with rod ends & hollow balls) (requires 5mm aluminum wrench #5477)
TRA9533R Traxxas Suspension arm, rear (right), red
TRA9534R Traxxas Suspension arm, rear (left), red
Turnbuckles, aluminum (red-anodized), toe links, 61mm (2)(assembled with rod ends & hollow balls) (fits Stampede) (requires 5mm aluminum wrench...
View full details
This is the Steel-Spline Constant Velocity Differential Output Shafts from Traxxas. Includes: (2) Differential Output Shafts Requires: Ins...
View full details
The Traxxas X-Maxx Heavy-Duty Right Lower Suspension Arm features a design which incorporates latest proprietary composite material. Traxxas design...
View full details
This is the Heavy Duty Lower Right Suspension Arm for the Traxxas X-Maxx Monster Truck. Features: Blue in color Heavy Duty Molded composite pla...
View full details
